MDT1005
1. General Description
This ROM-Based 8-bit micro-controller uses
a fully static CMOS design technology
combines higher speed and smaller size with
the low power and high noise immunity of
CMOS.
On chip memory system includes 0.5 K bytes
of ROM, and 32 bytes of static RAM.
u
Sleep Mode for power saving
u
8-bit real time clock/counter(RTCC) with
8-bit programmable prescaler
u
4 types of oscillator can be selected by
programming option:
RC-Low cost RC oscillator
LFXT-Low frequency crystal oscillator
XTAL-Standard crystal oscillator
HFXT-High frequency crystal oscillator
u
4 oscillator start-up time can be
selected by programming option:
150
µs,
20 ms, 40 ms, 80 ms
2. Features
The followings are some of the features on the
hardware and software :
u
Fully CMOS static design
u
8-bit data bus
u
On chip ROM size : 512 words
u
Internal RAM size : 32 bytes
(25 general purpose registers, 7 special
registers)
u
36 single word instructions
u
14-bit instructions
u
2-level stacks
u
Operating voltage : 2.3V ~ 6.3 V
u
Operating frequency : 0 ~ 20 MHz
u
The most fast execution time is 200 ns
under 20 MHz in all single cycle
instructions except the branch instruction
u
Addressing modes include direct, indirect
and relative addressing modes
u
Power-on Reset
u
Power edge-detector Reset
u
On-chip RC oscillator based Watchdog
Timer(WDT) can be operated freely
u
Pull up resistors for the following pins :
PA0~PA3, PB0~PB7, /MCLR, RTCC
u
Pull down resistors for the following pins :
PA0~PA3, PB0~PB7, RTCC
u
12 I/O pins with their own independent
direction control
3. Applications
The application areas of this MDT1005
range from appliance motor control and high
speed automotive to low power remote
transmitters/receivers, pointing devices, and
telecommunications processors, such as
Remote controller, small instruments,
chargers, toy, automobile and PC
peripheral … etc.
This specification are subject to be changed without notice. Any latest information please preview
http;//www.mdtic.com.tw
P.1
2005/6
Ver1.4