MDT10F630
EEIF : EEPROM Write Operation Interrupt Flag Bit.
0 = The EEPROM write operation is not completed or has not been start
1 = The EEPROM write operation completed (must be cleared in software)
CMIF : Comparator Interrupt Flag Bit.
0 = Comparator input has not changed
1 = Comparator input has changed (must be cleared in software)
TMR1IF : TMR1 Overflow Interrupt Flag Bit.
0 = Timer1 register did not overflow
1 = Timer1 register overflowed (must be cleared in software)
(13).
(14).
0DH : Unimplemented register.
0EH : TMR1L (The timer1 LSB register)
The LSB of the 16-bit TMR1.
0FH : TMR1H (The timer1 MSB register)
The MSB of the 16-bit TMR1.
10H : Timer1 control register.
Bit 7
T1STA
-
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
(15).
(16).
TMR1GE T1CKPS1 T1CKPS1 T1OSCEN /T1SYNC TMR1CLK TMR1ON
TMR1GE : Timer1 Gate Enable Bit.
If TMR1ON = 0 this bit is ignored
If TMR1ON = 1
0 = Timer1 is on
1 = Timer1 is on if /T1G pin is low
T1CKPS1 & T1CKPS0: Timer1 Input Clock Prescale Select bits.
0 0 = 1 : 1 Prescale value
0 1 = 1 : 2 Prescale value
1 0 = 1 : 4 Prescale value
1 1 = 1 : 8 Prescale value
T1OSCEN : LF Oscillator Enable Bit.
If INTOSC without CLKOUT oscillator is active :
0 = LP oscillator is off
1 = LP oscillator is enabled for Timer1 clock
/T1SYNC : Timer1 External Clock Input Synchronization Control Bit.
If TMR1CLK = 0 this bit is ignored
Timer1 use internal clock
If TMR1CLK = 1
0 = Synchronize external clock input
1 = Do not synchronize external clock input
TMR1CLK : Timer1 Clock Source Select Bit.
0 = Select internal clock Fosc/4
1 = Select External clock from T1CKI pin (on rising edge)
TMR1ON : TMR1 On Bit.
0 = Stop Timer1
1 = Enable Timer1
This specification is subject to be changed without notice. Please visit our web site for the most updated information.
http://www.mdtic.com.tw
P.7
2008/4
Ver. 1.0
MDTIC [ Micon Design Technology Corporation ]
