Analog to Digital Converter
ADCTL Register
ADCON
SPEED1 SPEED0
ADCI ADCS CHS2 CHS1 CHS0
ADCVL Register
-
-
-
-
-
-
B1
B0
ADCV Register
P1.7(AIN7)
P1.6(AIN6)
P1.5(AIN5)
P1.4(AIN4)
P1.3(AIN3)
P1.2(AIN2)
P1.1(AIN1)
P1.0(AIN0)
B9
B8
B7
B6
B5
B4
B3
B2
+
Successive
Approximation
Regiter
-
Comparator
10-bit DAC
10
The ADC on MPC82x54A is an 10-bit resolution, successive-approximation approach, and
medium-speed A/D converter. V
REFP
/ V
REFM
is the positive/negative reference voltage input for
internal voltage-scaling DAC use, and the typical sink current on it is 600uA ~ 1mA. For
MPC82x54A, these two references are internally tied to VDD and GND, separately.
Conversion is invoked since ADCS bit is set. Prior to ADC conversion, the desired I/O ports for
analog inputs should be configured as input-only or open-drain mode first. The conversion
takes around a fourth cycles to sample analog input data and other three fourths cycles in
successive-approximation steps. Total conversion time is controlled by two register bits –
SPEED1
and
SPEED0.
Analog input source comes from P1.x, one of the eight-channels is
multiplexed by analog multiplexer into the comparator. When conversion is completed, the
result will be saved onto {ADCV[7:0],
ADCVL[1:0]}
register. After the result has been loaded
onto {ADCV[7:0],
ADCVL[1:0]}
register,
ADCI
will be set.
ADCI
associated with its enable
register
AUXR.4(EADCI),
shares
ESPI
bit with
SPI
block to control the interrupt.
ADCI
should
be cleared in software. The ADC interrupt service routine vectors to 2B
H
. When the chip
enters idle mode or power-down mode, the power of ADC is turned off by hardware.
Vin – V
REFM
{ADCV,ADCVL[1:0]
= 1024 X
V
REFP
- V
REFM
54
MPC82x54A Data Sheet
MEGAWIN
MEGAWIN [ MEGAWIN TECHNOLOGY CO., LTD ]
