MLXSPI-01
MLXSPI Programming kit
The calculated values are now sent to the
MLXSPI programmer to be written into the
kitpart.
At the end all parameters are read back from
the kitpart to verify the programming cycle.
Note that the system does not check whether
the correct version of the kitpart is plugged
into the MLXSPI programmer.
Read:
The read command will read the values back
from the kitpart, will recalculate and display
the corresponding parameters in the
parameter definition interface.
The status bar indicates that the displayed
parameters correspond to the kitpart.
Evaluate:
The evaluate command is very similar to the
combination of the program and read
command, but it skips the connection to the
MLXSPI programmer.
The command starts with a consistency
check, it transforms the parameters to
programming values and then recalculates
and redisplays the corresponding parameters
in the parameter definition interface.
The result corresponds exactly to the values
that should have been programmed and
shows the result of the rounding process.
Exit:
This command exits the program.
Select parallel port:
This command gives the software the
possibility to connect to parallel port LPT1 or
LPT2.
9. Parameter definition interface
This part of the program interface is specific to
the different kitpart versions and therefore
consists of several pages, which can be selected
by clicking the tabs at the top side.
In this interface the values of all parameters are
defined. It is therefore the interface where the
behavior of the programmed kitpart is created.
The following sections will explain how to use the
parameter definition interface for the different
types of kitparts. It will however not explain in
detail how to define the parameters to obtain a
certain behavior. For this the datasheets and
application notes corresponding to the production
version of the kitpart should be consulted.
4.
5.
6.
7.
390129080401
Rev. 002
Page 5 of 9
User’s Guide
Mar/03
MELEXIS [ Melexis Microelectronic Systems ]
