欢迎访问ic37.com |
会员登录 免费注册
发布采购

MIC5219-3.0YM5 参数 Datasheet PDF下载

MIC5219-3.0YM5图片预览
型号: MIC5219-3.0YM5
PDF下载: 下载PDF文件 查看货源
内容描述: 值为500mA的峰值输出LDO稳压器 [500mA-Peak Output LDO Regulator]
分类和应用: 稳压器调节器光电二极管输出元件
文件页数/大小: 14 页 / 385 K
品牌: MICREL [ MICREL SEMICONDUCTOR ]
 浏览型号MIC5219-3.0YM5的Datasheet PDF文件第1页浏览型号MIC5219-3.0YM5的Datasheet PDF文件第2页浏览型号MIC5219-3.0YM5的Datasheet PDF文件第3页浏览型号MIC5219-3.0YM5的Datasheet PDF文件第4页浏览型号MIC5219-3.0YM5的Datasheet PDF文件第6页浏览型号MIC5219-3.0YM5的Datasheet PDF文件第7页浏览型号MIC5219-3.0YM5的Datasheet PDF文件第8页浏览型号MIC5219-3.0YM5的Datasheet PDF文件第9页  
Micrel, Inc.  
MIC5219  
Notes:  
1. Absolute maximum ratings indicate limits beyond which damage to the component may occur. Electrical specifications do not apply when operating  
the device outside of its operating ratings. The maximum allowable power dissipation is a function of the maximum junction temperature, T (max),  
J
the junction-to-ambient thermal resistance, θ , and the ambient temperature, T . The maximum allowable power dissipation at any ambient  
JA  
A
temperature is calculated using: P (max) = (T (max) – T ) ÷ θ . Exceeding the maximum allowable power dissipation will result in excessive die  
D
J
A
JA  
temperature, and the regulator will go into thermal shutdown. See Table 1 and the “Thermal Considerations” section for details.  
2. The device is not guaranteed to function outside its operating rating.  
3. Specification for packaged product only.  
4. Output voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature range.  
5. Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are tested for load regulation in the load range  
from 100µA to 500mA. Changes in output voltage due to heating effects are covered by the thermal regulation specification.  
6. Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its nominal value measured at 1V differen-  
tial.  
7. Ground pin current is the regulator quiescent current plus pass transistor base current. The total current drawn from the supply is the sum of the load  
current plus the ground pin current.  
8.  
V
is the voltage externally applied to devices with the EN (enable) input pin.  
EN  
9. Thermal regulation is defined as the change in output voltage at a time “t” after a change in power dissipation is applied, excluding load or line regu-  
lation effects. Specifications are for a 500mA load pulse at V = 12V for t = 10ms.  
IN  
10. C  
is an optional, external bypass capacitor connected to devices with a BYP (bypass) or ADJ (adjust) pin.  
BYP  
June 2009  
5
M0371-061809