WRA-YD-20W&WRB-YD-20W Series(2.16)
OUTLINE DIMENSIONS
&
FOOTPRINT DETAILS
MECHANICAL DIMENSIONS
RECOMMENDED FOOTPRINT
Note:
Unit:mm(inch)
Pin diameter:1.00mm(0.039inch)
Pin diameter tolerances:±0.05mm(±0.002inch)
General tolerances:±0.25mm(±0.010inch)
Top view grid:2.54mm(0.1inch)
Diameter:1.50mm(0.059inch)
FOOTPRINT DETAILS
TUBE OUTLINE DIMENSIONS
Pin
1
2
3
4
5
6
7
Single
Vin
GND
CTRL
Trim
-Vo
+Vo
No Pin
Dual
Vin
GND
CTRL
Trim
-Vo
Common
+Vo
Note: The CTRL control pin voltage is referenced to GND
When the environment temperature is higher than 71℃, the
product output power should be less then 60% of the rated
power.
No parallel connection or plug and play.
Use dual output simultaneously,forbid pening output pin (0V)
to use as single output.
Note:
1. The CTRL control pin voltage is referenced to GND.
2. Typical efficiency value at nominal input voltage and full load.
Note:
Unit :mm[inch]
General tolerances:±0.250mm[±0.010inch]
3. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified.
4. In this data sheet, all the test methods of indications are based on corporate standards.
5. Capacitor MAX load tested at nominal input voltage and constant resistive load.
Technical Enquiries-Email:tech@microdc.cn Tel:0086-20-86000646
Page 3
3
of 3