DATA SHEET
HAL 2xy
1.4. Operating Junction Temperature Range
The Hall sensors from Micronas are specified to the
chip temperature (junction temperature T
J
).
K:
T
J
=
−40 °C
to +140
°C
Note:
Due to power dissipation, there is a difference
between the ambient temperature (T
A
) and
junction temperature. Please refer to section
Unipolar Sensors:
The output turns low with the magnetic south pole on
the branded side of the package and turns high if the
magnetic field is removed. The sensor does not
respond to the magnetic north pole on the branded side.
Latching Sensors:
The sensors have a latching behavior and require a
magnetic north and south pole for correct functioning.
The output turns low with the magnetic south pole on
the branded side of the package and turns high with
the magnetic north pole on the branded side. The
output does not change if the magnetic field is
removed. For changing the output state, the opposite
magnetic field polarity must be applied.
Unipolar Switching Sensors with Inverted Output
Sensitive to North Pole:
The output turns high with the magnetic north pole on
the branded side of the package and turns low if the
magnetic field is removed. The sensor does not
respond to the magnetic south pole on the branded-
side.
Hall Sensor Package Codes
HALXXXPA-T
Temperature Range: K
Package: TQ for SOT89B-3
JQ for TO92UA-5/6
Type: 2xy
Example:
HAL202JQ-K
→
Type: 202
→
Package: TO92UA-6
→
Temperature Range: T
J
=
−40 °C
to +140
°C
Hall sensors are available in a wide variety of packag-
ing versions and quantities. For more detailed informa-
tion, please refer to the brochure: “Hall Sensors.
Ordering Codes, Packaging, Handling”.
1.3. Marking Code
All Hall sensors have a marking on the package
surface (branded side). This marking includes the
name of the sensor and the temperature range.
Type
Temperature Range
K
1.5. Solderability and Welding
During soldering reflow processing and manual
reworking, a component body temperature of 260
°C
should not be exceeded.
Device terminals shall be compatible with laser and
electrical welding. Please, note that the success of the
welding process is subject to different welding parame-
ters which will vary according to the welding technique
used. A very close control of the welding parameters is
absolutely necessary in order to reach satisfying
results. Micronas, therefore, does not give any implied
or express warranty as to the ability to weld the com-
ponent.
HAL201
HAL202
HAL203
HAL204
HAL206
HAL207
HAL208
HAL210
HAL211
HAL212
HAL220
HAL221
201K
202K
203K
204K
206K
207K
208K
210K
211K
212K
220K
221K
1 V
DD
3
OUT
2 GND
Fig. 1–1:
Pin configuration
Micronas
Jan. 11, 2010; DSH000141_003EN
5
MICRONAS [ MICRONAS ]
