53111
Power MOSFET Optocoupler
TYPICAL CHARACTERISTICS
All typical values are at T
A
= 25°C, I
F (ON)
= 10mA, V
F (OFF)
= 0.6V unless otherwise specified.
Parameter
Symbol
Test
Conditions
V
O
= 28 V
f = 1 MHz
I
F
= 10 mA
I
O
= 0 mA
I
F
= 10 mA
V
F
= 0 V
f = 1 MHz
V
I-O
= 0 V
f = 1 MHz
V
I-O
= 500 V
t = 60 s
Typ.
Units
Notes
Output Off-Capacitance
Output Offset Voltage
Input Diode Temperature
Coefficient
Input Capacitance
Input-Output
Capacitance
Input-Output Resistance
C
O (OFF)
V
OS
∆V
F
/∆T
A
C
IN
C
I-O
R
I-O
145
2
-1.4
20
1.5
10
13
pF
µV
mV/°C
pF
pF
Ω
7
4
4
6
Notes:
1. Maximum junction to case thermal resistance for the device is 15ºC/W, where case temperature, T
C
, is
measured at the center of the package bottom.
2. For rating, see Figure 5. The output power P
D
rating curve is obtained when the part is handling the maximum
average output current I
O
as shown in Figure 3.
3. During the pulsed R
ON
measurement (I
O
duration < 30 ms), ambient (T
A
) and case temperature (T
C
) are equal.
4. Pins 2 through 3 shorted together and pins 5 through 8 shorted together.
5. This is a momentary withstand test, not an operating condition.
6. V
OS
is a function of I
F
and is defined between pins 5 and 8, with pin 5 as the reference. V
OS
must be measured
in a stable ambient (free of temperature gradients).
7. Zero-bias capacitance measured between the LED anode and cathode.
CAUTION:
Care should be taken not to exceed the maximum output power dissipation, maximum case temperature, and
maximum junction temperature when repetitively switching loads.
Micropac Industries
cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac
reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCS PRODUCTS DIVISION
•
905 E. Walnut St., Garland, TX 75040
•
(972) 272-3571
•
Fax (972) 494-2281
E-MAIL:
hybridsales@micropac.com
5/22/02
www.micropac.com
Pg. 4 of 11