53259
POWER MOSFET OPTOCOUPLER
400V / 50Ω HERMETICALLY SEALED
Mii
MICROCIRCUITS DIVISION
Features:
•
•
•
•
•
•
•
•
•
•
Hermetically Sealed 8-Pin Dual-In-Line
package
Normally Closed Contact
Performance over –55°C to +125°C Ambient
Temperature Range
±400 VDC Blocking Voltage in Bi-directional
Mode
AC/DC Switching
Maximum AC / DC Load Current: 0.12 A / 0.24 A
1500 VDC Withstand Test Voltage
Optically Isolated
1.5 A Output Surge Current
Same foot print as HSSR 7111 / Mii 53111
Applications:
•
•
•
•
•
•
•
•
Satellite / Space Systems
Military / High Reliability Systems
Power Distribution Control
AC/DC Electromechanical or Reed Relay
Replacement
I/O Modules for Automated Test Equipment
Process Control
Telecom Applications
Medical Electronics
DESCRIPTION
The 53259 is a single channel power MOSFET optocoupler. Low on-resistance of the MOSFET outputs, combined
with 1500 VDC isolation between input and output, makes this optocoupler ideal for many solid state relay
applications. Operation is specified over the full military temperature range. The part is supplied in an eight-pin,
dual-in-line ceramic package, available in variety of quality levels from COTS to class K including any custom
screening requirements. The basic data sheet part is environmentally screened to H level in accordance with Table
C-IX of MIL-PRF-38534. For ordering part number; consult with Micropac factory for detail. The part is normally
shipped with gold plated leads, but lead finishes per MIL-PRF-38534 are available.
Functionally, the device operates as a single-pole, normally closed (1 Form B) solid state relay. The device is
actuated by an input current, which can be supplied from standard logic types such as open-collector TTL. The
input current biases a light emitting diode that is optically coupled to an integrated photovoltaic diode array. The
photovoltaic array powers control circuitry that operates the output MOSFETs.
Optimum switching of either AC or DC loads is provided by a configurable output. For AC loads, connection A in
Figure 1 must be used. Connection A will also switch DC loads but connection B, in Figure 1, provides DC-only
operation with the advantages of substantial reduction in on-resistance and twice the output current capability as
that obtained with connection A.
Micropac Industries
cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac
reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCIRCUITS DIVISION
•
905 E. Walnut St., Garland, TX 75040
•
(972) 272-3571
•
Fax (972) 494-2281
www.micropac.com
E-MAIL: hybridsales@micropac.com
7/29/02
Pg. 1 of 6
MII [ Micropac Industries ]
