MOTOROLA
Designer's
SEMICONDUCTOR TECHNICAL DATA
Order this document
by MBRS1100T3/D
Schottky Power Rectifier
Surface Mount Power Package
Schottky Power Rectifiers employ the use of the Schottky Barrier principle in
a large area metal-to-silicon power diode. State-of-the-art geometry features
epitaxial construction with oxide passivation and metal overlay contact. Ideally
suited for low voltage, high frequency rectification, or as free wheeling and
polarity protection diodes, in surface mount applications where compact size
and weight are critical to the system. These state-of-the-art devices have the
following features:
•
•
•
•
•
•
Small Compact Surface Mountable Package with J-Bend Leads
Rectangular Package for Automated Handling
Highly Stable Oxide Passivated Junction
High Blocking Voltage — 100 Volts
150°C Operating Junction Temperature
Guardring for Stress Protection
™
Data Sheet
MBRS1100T3
Motorola Preferred Device
SCHOTTKY BARRIER
RECTIFIER
1.0 AMPERE
100 VOLTS
Mechanical Characteristics
•
Case: Epoxy, Molded
•
Weight: 95 mg (approximately)
•
Finish: All External Surfaces Corrosion Resistant and Terminal Leads are
Readily Solderable
•
Lead and Mounting Surface Temperature for Soldering Purposes: 260°C
Max. for 10 Seconds
•
Shipped in 12 mm Tape and Reel, 2500 units per reel
•
Polarity: Notch in Plastic Body Indicates Cathode Lead
•
Marking: B110
MAXIMUM RATINGS
Rating
Peak Repetitive Reverse Voltage
Working Peak Reverse Voltage
DC Blocking Voltage
Average Rectified Forward Current
TL = 120°C
TL = 100°C
Symbol
VRRM
VRWM
VR
IF(AV)
IFSM
TJ
dv/dt
CASE 403A–03
Value
100
Unit
Volts
1.0
2.0
50
– 65 to +150
10
Amps
Amps
°C
V/ns
Nonrepetitive Peak Surge Current
(Surge applied at rated load conditions halfwave, single phase, 60 Hz)
Operating Junction Temperature
Voltage Rate of Change
THERMAL CHARACTERISTICS
Thermal Resistance — Junction to Lead (TL = 25°C)
R
θJL
22
°C/W
ELECTRICAL CHARACTERISTICS
Maximum Instantaneous Forward Voltage (1)
(iF = 1.0 A, TJ = 25°C)
Maximum Instantaneous Reverse Current (1)
(Rated dc Voltage, TJ = 25°C)
(Rated dc Voltage, TJ = 100°C)
(1) Pulse Test: Pulse Width = 300
µs,
Duty Cycle
≤
2.0%.
Preferred
devices are Motorola recommended choices for future use and best overall value.
Designer’s Data for “Worst Case” Conditions
— The Designer’s Data Sheet permits the design of most circuits entirely from the information presented. SOA Limit
curves — representing boundaries on device characteristics — are given to facilitate “worst case” design.
VF
iR
0.75
Volts
mA
0.5
5.0
Rev 2
©
Rectifier
Inc. 1996
Data
Motorola,
Device
1
MOTOROLA [ MOTOROLA, INC ]
