MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Order this document
by MOC8050/D
MOC8030
GlobalOptoisolator™
[CTR = 300% Min]
6-Pin DIP Optoisolators
Darlington Output
(No Base Connection)
The MOC8030 and MOC8050 devices consist of gallium arsenide infrared
emitting diodes optically coupled to monolithic silicon photodarlington detec-
tors. The chip to Pin 6 base connection has been eliminated to improve output
performance in high noise environments.
They are best suited for use in applications susceptible to high EMI levels.
•
•
•
•
No Base Connection for Improved Noise Immunity
High Collector–Emitter Breakdown Voltage — 80 Volts Minimum
Higher Sensitivity to Low Input Drive Current
To order devices that are tested and marked per VDE 0884 requirements, the
suffix ”V” must be included at end of part number. VDE 0884 is a test option.
Applications
•
Appliances, Measuring Instruments
•
I/O Interfaces for Computers
•
Programmable Controllers
•
Portable Electronics
•
Interfacing and coupling systems of different potentials and impedance
•
Solid State Relays
MAXIMUM RATINGS
(TA = 25°C unless otherwise noted)
Rating
INPUT LED
Reverse Voltage
Forward Current — Continuous
LED Power Dissipation @ TA = 25°C
with Negligible Power in Output Detector
Derate above 25°C
OUTPUT DETECTOR
Collector–Emitter Voltage
Collector Current Continuous
Emitter–Collector Voltage
Detector Power Dissipation @ TA = 25°C
with Negligible Power in Input LED
Derate above 25°C
TOTAL DEVICE
Isolation Surge Voltage(1)
(Peak ac Voltage, 60 Hz, 1 sec Duration)
Total Device Power Dissipation @ TA = 25°C
Derate above 25°C
Ambient Operating Temperature Range(2)
Storage Temperature Range(2)
VISO
PD
TA
Tstg
7500
250
2.94
– 55 to +100
– 55 to +150
Vac(pk)
mW
mW/°C
°C
°C
VCEO
IC
VECO
PD
80
150
5
150
1.76
Volts
mA
Volts
mW
mW/°C
VR
IF
PD
3
60
120
1.41
Volts
mA
mW
mW/°C
Symbol
Value
Unit
MOC8050
[CTR = 500% Min]
Motorola Preferred Devices
STYLE 3 PLASTIC
6
1
STANDARD THRU HOLE
CASE 730A–04
SCHEMATIC
1
2
3
PIN 1.
2.
3.
4.
5.
6.
LED ANODE
LED CATHODE
N.C.
EMITTER
COLLECTOR
N.C.
6
5
4
Soldering Temperature (10 sec, 1/16″ from case)
TL
260
°C
1. Isolation surge voltage is an internal device dielectric breakdown rating.
1.
For this test, Pins 1 and 2 are common, and Pins 4 and 5 are common.
2. Refer to Quality and Reliability Section in Opto Data Book for information on test conditions.
Preferred
devices are Motorola recommended choices for future use and best overall value.
GlobalOptoisolator is a trademark of Motorola, Inc.
REV 2
©
Motorola
Inc. 1995
Motorola,
Optoelectronics Device Data
1
MOTOROLA [ MOTOROLA, INC ]
