TYPICAL CONNECTION CIRCUIT
The connection circuit shown above is for the MSK 1902-0 evaluation board. The Rp and Lp are external compo-
nents and must not be located near ground planes if possible. A high quality resistor such as Bradford Electronics P/
N FP10-400 is required for optimum response times. Use an inductor with a high self-resonant frequency that can
withstand the currents required for the application.
When using the other variants of the MSK 1902, place an additional bypass capacitor on pins 16 and 17 if series
(Rp and Lp) components are not utilized. The pin should connect to +V
HV
with a short low impedance path.
For additional application information, please contact MSK. Evaluation amplifiers with test boards are available
upon request.
NOTES:
5
Rev. B 2/03
MSK [ M.S. KENNEDY CORPORATION ]
