ACA5-20PC Series
TYPICAL WIRING DIAGRAMS
First pass and carefully dress one output wire from the external CT
through the on-board CT (L1). Then connect the ac supply to TB1
as shown. If required, verify that correct line-power polarities are
applied to the external load (see Technical Note 4). Ensure all wires
are stripped and terminals torqued correctly. For proper operation,
pass only a single wire through the on-board CT's center hole.
�½ �½ �½ �½ �½�½ �½ �½ �½ �½�½ �½�½ �½ �½
5 Amp Input LED-Display AC Ammeters
�½ �½ �½�½ �½ �½ �½ �½
�½ �½ �½ �½ �½ �½
�½ �½ �½
�½ �½ �½
�½ �½ �½�½ �½ �½ �½
�½
�½
�½ �½
�½ �½ �½ �½ �½ �½ �½ �½
�½ �½ �½�½ �½ �½ �½ �½ �½ �½�½ �½ �½ �½ �½ �½ �½
�½ �½ �½ �½ �½ �½ �½ �½ �½ �½ �½
�½ �½�½ �½
�½ �½ �½ �½ �½ �½
Figure 3. ACA5-20PC AC-Powered Models
First pass and carefully dress one output wire from the external
CT through the on-board CT (L1). Then connect the two dc power-
supply wires to TB1, observing correct positive ("+") and negative
("–") polarities. Ensure all wires are stripped and terminals
torqued correctly. For proper operation, pass only a single wire
through the on-board CT's center hole.
�½
�½ �½ �½�½ �½ �½ �½ �½
�½ �½ �½ �½ �½ �½ �½
�½ �½ �½ �½ �½�½ �½ �½ �½ �½�½ �½�½ �½ �½
�½ �½ �½
�½ �½ �½
�½ �½ �½�½ �½ �½ �½
�½
�½
�½
�½
�½ �½
�½ �½ �½ �½ �½ �½ �½ �½
�½ �½ �½�½ �½ �½ �½ �½ �½ �½�½ �½ �½ �½ �½ �½ �½
�½ �½ �½ �½ �½ �½ �½ �½ �½ �½ �½
Figure 4. ACA5-20PC DC-Powered Models
�½ �½�½ �½
�½ �½ �½ �½ �½ �½
www.murata-ps.com
Technical enquiries
email: sales@murata-ps.com, tel:
+1 508 339 3000
MPM_ACA520PC_B02
Page 4 of 5
MURATA-PS [ MURATA POWER SOLUTIONS INC. ]
