MECHANICAL (THROUGH HOLE)
PIN FUNCTIONS
1
2
3
4
5
6
7
8
+Vin
Remote On/Off
-Vin
-Vout
- Sense
Trim
+ Sense
+Vout
NOTES:
General Tolerance;
±
.015
Pin Locations/Diameters:
±
.005
Dimensions are in inches
[Millimeters]
Pin material: Copper
Pin Finish: Matte Tin over Nickel
Converter weight: [30.8g]
UL/TUV Standards require a clearance
greater than 0.06” between input and
output for Basic insulation. This should be
considered if copper traces are used on
the top side of the board under the con-
verter unit. Ferrite cores are considered
part of the input/primary circuit.
MECHANICAL (SMT)
Interconnect FUNCTIONS
1
2
3
4
5
6
7
8
+Vin
Remote On/Off
-Vin
-Vout
- Sense
Trim
+ Sense
+Vout
NOTES:
General Tolerance;
±
.015
Interconnect Locations/
Diameters:
±
.005
Dimensions are in inches
[Millimeters]
Pin material: Copper
Pin Finish: Matte Tin over Nickel
Converter weight: [30.8g]
UL/TUV Standards require a clearance
greater than 0.06” between input and
output for Basic insulation. This should be
considered if copper traces are used on
the top side of the board under the con-
verter unit. Ferrite cores are considered
part of the input/primary circuit.
* Interconnect co-planarity within 0.004”
SLC100 Rev B
5/2004
3
MURATA-PS [ MURATA POWER SOLUTIONS INC. ]
