CONDUCTIVE POLYMER
ALUMINUM SOLID ELECTROLYTIC CAPACITORS
LG
Radial Lead Type, Higher Capacitance
series
Higher Capacitance, Low ESR, High ripple current.
Load life of 2000 hours at 105
°C.
Radial lead type :
Lead free flow soldering condition correspondence
Adapted to the RoHS directive (2002/95/EC).
LG
Higher
Capacitance
LF
Specifications
Item
Category Temperature Range
Rated Voltage Range
Rated Capacitance Range
Capacitance Tolerance
tan
δ
ESR ( 1)
Leakage Current ( 2)
–55 to +105°C
2.5 to 16V
330 to 3900µF
±
20% at 120Hz, 20°C
Not more than value of Standard ratings
Not more than value of Standard ratings
Not more than value of Standard ratings.
1.25
1.25
Capacitance change
tan
δ
ESR ( 1)
Leakage current ( 2)
Within
±
20% of initial value ( 3)
150% or less of the initial specified value
150% or less of the initial specified value
Initial specified value or less
(100kHz)
at 120Hz, 20°C
at 100kHz, 20°C
After 2 minute's application of rated voltage.
20°C
Performance Characteristics
Characteristics of Temperature Z+105°C / Z + 20°C
Impedance Ratio
Z - 55°C / Z + 20°C
After 2000 hours' application of rated voltage
Endurance
at 105°C, capacitors meet the specified value
for life characteristics listed at right.
After 1000 hours' application of rated voltage
Damp Heat
at 60°C 90%RH, capacitors meet the specified
value for life characteristics listed at right.
Capacitance change
tan
δ
ESR ( 1)
Leakage current ( 2)
Within
±
20% of initial value ( 3)
150% or less of the initial specified value
150% or less of the initial specified value
Initial specified value or less
Resistance to
Soldering Heat
To comply with recommended conditions for
reflow soldering. Pre-heating shall be done
at 150 to 200°C and for 60 to 180 sec.
Peak temp. is 265°C, within 10 sec.
Measurement for solder temperature profile
shall be made at a point on the terminal
nearest where the terminals protrude through
the soldering side of PC board.
Navy blue print on the case top.
Capacitance change
tan
δ
ESR ( 1)
Leakage current ( 2)
Within
±
10% of initial value ( 3)
130% or less of the initial specified value
130% or less of the initial specified value
Initial specified value or less
Marking
( 1) ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor.
( 2) Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes
at the temperature of 105°C.
( 3) Initial value : The value before test of examination of resistance to soldering.
NICHICON [ NICHICON CORPORATION ]
