LM2594M-5.0 参数 Datasheet PDF下载

LM2594/LM2594HV

All Output Voltage Versions

Electrical Characteristics

(Continued)

Note 2:

The human body model is a 100 pF capacitor discharged through a 1.5k resistor into each pin.

Note 3:

Typical numbers are at 25˚C and represent the most likely norm.

Note 4:

All limits guaranteed at room temperature (standard type face) and at temperature extremes (bold type face). All room temperature limits are 100% produc-

tion tested. All limits at temperature extremes are guaranteed via correlation using standard Statistical Quality Control (SQC) methods. All limits are used to calculate

Average Outgoing Quality Level (AOQL).

Note 5:

External components such as the catch diode, inductor, input and output capacitors, and voltage programming resistors can affect switching regulator sys-

tem performance. When the LM2594/LM2594HV is used as shown in the

Figure 1

test circuit, system performance will be as shown in system parameters section

of Electrical Characteristics.

Note 6:

The switching frequency is reduced when the second stage current limit is activated. The amount of reduction is determined by the severity of current over-

load.

Note 7:

No diode, inductor or capacitor connected to output pin.

Note 8:

Feedback pin removed from output and connected to 0V to force the output transistor switch ON.

Note 9:

Feedback pin removed from output and connected to 12V for the 3.3V, 5V, and the ADJ. version, and 15V for the 12V version, to force the output transistor

switch OFF.

Note 10:

V

IN

= 40V for the LM2594 and 60V for the LM2594HV.

Note 11:

Junction to ambient thermal resistance with approximately 1 square inch of printed circuit board copper surrounding the leads. Additional copper area will

lower thermal resistance further. See application hints in this data sheet and the thermal model in Switchers Made Simple

®

software.

Typical Performance Characteristics

Normalized

Output Voltage

Line Regulation

Efficiency

DS012439-5

DS012439-4

DS012439-6

Switch Saturation

Voltage

Switch Current Limit

Dropout Voltage

DS012439-8

DS012439-7

DS012439-9

5

www.national.com