Signal descriptions
M29W320ET, M29W320EB
2.7
2.8
Write Enable (W)
The Write Enable, W, controls the Bus Write operation of the memory’s Command interface.
VPP/Write Protect (VPP/WP)
The V /Write Protect pin provides two functions. The V function allows the memory to
PP
PP
use an external high voltage power supply to reduce the time required for Program
operations. This is achieved by bypassing the unlock cycles and/or using the Double word or
Quadruple byte Program commands.
The Write Protect function provides a hardware method of protecting the two outermost boot
blocks. When V /Write Protect is Low, V , the memory protects the two outermost boot
PP
IL
blocks; Program and Erase operations in these blocks are ignored while V /Write Protect is
PP
Low, even when RP is at V .
ID
When V /Write Protect is High, V , the memory reverts to the previous protection status
PP
IH
of the two outermost boot blocks. Program and Erase operations can now modify the data
in these blocks unless the blocks are protected using Block Protection.
When V /Write Protect is raised to V the memory automatically enters the Unlock
PP
PP
Bypass mode. When V /Write Protect returns to V or V normal operation resumes.
PP
IH
IL
During Unlock Bypass Program operations the memory draws I from the pin to supply the
PP
programming circuits. See the description of the Unlock Bypass command in the Command
interface section. The transitions from V to V and from V to V must be slower than
IH
PP
PP
IH
t
, see Figure 16
VHVPP
Never raise V /Write Protect to V from any mode except Read mode, otherwise the
PP
PP
memory may be left in an indeterminate state.
The V /Write Protect pin must not be left floating or unconnected or the device may
PP
become unreliable. A 0.1µF capacitor should be connected between the V /Write Protect
PP
pin and the V Ground pin to decouple the current surges from the power supply. The PCB
SS
track widths must be sufficient to carry the currents required during Unlock Bypass Program,
I .
PP
2.9
Reset/Block Temporary Unprotect (RP)
The Reset/Block Temporary Unprotect pin can be used to apply a Hardware Reset to the
memory or to temporarily unprotect all Blocks that have been protected.
Note that if V /WP is at V , then the two outermost boot blocks will remain protected even
PP
IL
if RP is at V .
ID
A Hardware Reset is achieved by holding Reset/Block Temporary Unprotect Low, V , for at
IL
least t
. After Reset/Block Temporary Unprotect goes High, V , the memory will be
PLPX
IH
ready for Bus Read and Bus Write operations after t
or t
, whichever occurs last.
RHEL
PHEL
See the Ready/Busy Output section, Table 16 and Figure 15: Reset/Block Temporary
Unprotect ac waveforms, for more details.
Holding RP at V will temporarily unprotect the protected Blocks in the memory. Program
ID
and Erase operations on all blocks will be possible. The transition from V to V must be
IH
ID
slower than t
.
PHPHH
14/63