欢迎访问ic37.com |
会员登录 免费注册
发布采购

RS7202-20GRLNEG 参数 Datasheet PDF下载

RS7202-20GRLNEG图片预览
型号: RS7202-20GRLNEG
PDF下载: 下载PDF文件 查看货源
内容描述: 250毫安低静态线性稳压器与启用 [250mA Low Quiescent Linear Regulator with Enable]
分类和应用: 稳压器
文件页数/大小: 7 页 / 480 K
品牌: ORISTER [ ORISTER CORPORATION ]
 浏览型号RS7202-20GRLNEG的Datasheet PDF文件第1页浏览型号RS7202-20GRLNEG的Datasheet PDF文件第2页浏览型号RS7202-20GRLNEG的Datasheet PDF文件第3页浏览型号RS7202-20GRLNEG的Datasheet PDF文件第5页浏览型号RS7202-20GRLNEG的Datasheet PDF文件第6页浏览型号RS7202-20GRLNEG的Datasheet PDF文件第7页  
页页次: 4/7
详细说明
The RS7202 is a low quiescent current LDO linear regulator. The device provides preset 1.8V, 2.5V and 3.3V output voltages 
for output current up to 350mA. Other mask options for special output voltages from1.5V to 5.0V with 100mV increment are 
也可提供。所示的功能框图,它包括一个1.23V的电压,误差放大器,一个P沟道通
晶体管的ON / OFF控制逻辑,以及内部反馈电压分压器。
 
The 1.23V bandgap reference is connected to the error amplifier, which compares this reference with the feedback voltage 
并且放大电压差。如果反馈电压低于基准电压时,所述传送晶体管栅极是
拉到低,这允许更多的电流传递到输出引脚,并增加输出电压。如果反馈电压
过高时,导通晶体管的栅极被向上拉,以减少输出电压。
 
输出电压是通过内部的电阻分压器连接到V反馈
OUT
 
引脚。其他模块包括与
输出电流限制器和关断逻辑。
 
内部P沟道MOSFET
该RS7202拥有一个P沟道MOSFET晶体管。不像使用PNP调整晶体管类似的设计时,P沟道
MOSFET的不需要基极驱动,从而降低了静态电流。 PNP型监管机构也浪费了相当大的电流
dropout conditions when the pass transistor saturates, and use high base‐drive currents under large loads. The RS7202 does 
not suffer from these problems and consumes only 2.0μA (Typical) of current consumption under light loads. 
 
使能功能
EN引脚启动以及停止稳压器。当EN引脚被切换到关闭电源电平,所有内部电路的动作
停止时,引脚V的积聚在P沟道MOSFET输出晶体管
IN
 
和V
OUT
 
关闭时,允许电流
消耗大幅度减少。在V
OUT
销进入GND电平由于反馈的几MΩ的电阻
V之间的电压分压器
OUT
和GND引脚。
 
输出电压选择
该RS7202输出电压预置为一个内部调整电压1.8V , 2.5V或3.3V 。的输出电压也可以是
面具选配,从1.2V到5.0V ,具有100mV的增量特殊订单(但只有1.28V的1.3V代替) 。前两个
digits of part number suffix identify the output voltage (see Ordering Information). For example, RS7202‐33 has a preset 3.3V 
输出电压。
 
电流限制
The RS7202 also includes a fold back current limiter. It monitors and controls the pass‐transistor’s gate voltage, estimates the 
output current, and limits the output current within 350mA. 
 
热过载保护
Thermal overload protection limits total power dissipation in the RS7202. When the junction temperature exceeds T
J
=+155°C, 
热传感器关断导通晶体管,使IC降温。热传感器接通传输晶体管
再次激活后的结点温度由10℃冷却下来,从而产生一个脉冲输出期间连续热
过载的情况。
 
Thermal overload protection is designed to protect the RS7202 in the event of fault conditions. For continuous operation, the 
的T最大工作结温额定值
J
=+125°C should not be exceeded. 
 
输入输出电压差
监管机构的最小输入输出电压差,或压差电压,确定最低可用电源电压。在
电池供电的系统,这将决定报废的有用电池电压。的RS7202采用P沟道MOSFET
导通晶体管,其电压差是漏极 - 源极导通电阻( R的函数
DS ( ON)
)乘以负载电流。
 
V
=
V
IN
V
OUT
=
R
DS
(
ON
)
×
I
OUT
 
 
 
 
DS‐RS7202‐05 
   
April, 2011 
www.Orister.com