CT-100A
CRIMPING TOOL OPERATION INSTRUCTIONS
© Panduit Corp. 2007
PA25519A01
REV: 00 11-2007
CT-100A
CRIMPING TOOL
OPERATION INSTRUCTIONS
WARNING:
Electric Shock Hazard:
Do NOT use this tool
on live wire.
Verify power is “OFF” before
working on wiring with this tool.
The plastic grips are for the user’s comfort,
and are not intended to insulate against
electrical shock while working on
live electrical circuits.
See product packaging or contact Customer Service for UL/CSA
approved tooling/product combination.
NOTE: In the interest of higher quality and value, PANDUIT products are continually
being improved and updated. Consequently, pictures may vary from the enclosed
product.
WIRE CUTTER
for No. 10
AWG and smaller copper wire.
CRIMPING DIES
for
P
AN
-T
ERM
insulated terminals, disconnects,
splices and wire joints on No. 22 to
10 AWG stranded wire.
CUTTERS
for machine screws
of sizes shown, open handles,
thread in this side. Closing handles
cuts screw 0.15" below surface.
CRIMPING DIE
for
P
AN
-T
ERM
non-insulated terminals, disconnects,
splices and wire joints on No. 22 to
10 AWG solid or stranded wire.
CRIMP POCKETS A and B
for
additional terminals and disconnects
per instructions on product packaging.
WIRE LOOP HOLES (2)
WIRE STRIPPER
for removing plastic
or rubber wire insulation. Strip length
should allow a minimum of 1/32" of
conductor to extend beyond
terminal barrel.
red dot
blue dot
yellow dot
This tool is made
of hardened steel
and is protected
with a light coat
of oil.
CRIMP POCKET
NON-INSULATED AND INSULATED
PARALLEL SPLICE INSTRUCTIONS
1. Insert stripped wire into each end of the
parallel splice. (See product packaging for
proper strip lengths.)
2. Locate parallel splice in proper crimp
pocket.
3. Position crimp pocket on the center of the
metal barrel.
4. Squeeze handles firmly.
For Technical Support:
888-506-5400, ext. 3255
Fax: 630-759-7532
Page: 1 of 2
www.panduit.com
E-mail: cs@panduit.com
PANDUIT [ PANDUIT CORP. ]
