SPECIFICATION CONTROL DRAWING
Product Rev
Product
Name
D-300-01
D-300-02
D-300-03
A±2.54
(A±0.100)
25.40
(1.000)
27.90
(1.100)
33.02
(1.300)
Product Dimensions
As Received
After Free Recovery
øB
min
4.45
(0.175)
6.35
(0.250)
9.14
(0.360)
W
min
0.25
(0.010)
0.38
(0.015)
0.38
(0.015)
øB
max
2.03
(0.080)
3.05
(0.120)
4.57
(0.180)
W
min
0.76
(0.030)
1.02
(0.040)
1.27
(0.050)
Maximum
Weight
Pounds/mpc
1.15
2.55
4.50
E
E
E
MATERIALS
1. MOLDED CAP: Heat-shrinkable, cross-linked, flame-retarded modified polyolefin.
2. MELTABLE RING: Modified thermoplastic.
APPLICATION
1. These parts are designed to meet the requirements as shown in the Requirements Section when tested as listed.
2. Parts to be assembled as outlined herein.
3. “B” recovered is the maximum inside diameter of the heat-shrinkable cap.
4. “W” is the wall thickness of the heat-shrinkable cap only, and is measured along the vertical wall.
5. “A” is the average length of the cap and is equal to (A min + A max)/2.
1.0
SCOPE
This document covers the requirements and test procedures applicable to heat shrinkable, stub-splice
encapsulation cap (caps) and the molded component thereof.
2.0
APPLICABLE DOCUMENTS
The specifications and standards referenced herein shall form part of this specification to the extent
specified.
307 Constitution Drive Menlo Park, CA 94025, USA
Wire and
Harnessing
Products
TITLE :
CAP, SPLICE ENCAPSULATION
DOCUMENT NO.:
DCR NUMBER:
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
Tyco Electronics reserves the right to amend
ANGLES: N/A
TOLERANCES:
this drawing at any time. Users should
0.00 N/A
evaluate the suitability of the product for
ROUGHNESS IN
0.0 N/A
their application.
MICRON
0 N/A
D-300-01/-03
REPLACES:
D010043
SCALE:
None
SIZE:
A
N/A
SHEET:
1 of 7
DRAWN BY:
DATE:
PROD. REV.
DOC ISSUE:
M. FORONDA
15-Feb.-01
SEE TABLE
1
If this document is printed it becomes uncontrolled. Check for the latest revision.
PANDUIT [ PANDUIT CORP. ]
