D-436-43 参数 Datasheet PDF下载

SPECIFICATION CONTROL DRAWING

MATERIALS

1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene

flouride.

2. INTEGRAL MULTI-WIRE SEAL: Modified thermoplastic.

3. SEPARATE MULTI-WIRE SEAL: Modified thermoplastic.

4. CRIMP SPLICER: Base Metal: Copper Alloy 101 or 102 per ASTM B-75.

Plating: Tin per MIL-T-10727, Type 1.

Color Code: See table below.

Part

Name

D-436-42

D-436-43

Prod.

Rev.

F

A

Dimensions: Crimp Splice

I.D.±0.05

O.D.±0.08

Color

(I.D.±0.002) (O.D.±0.003)

Code

1.70 (0.067)

2.62 (0.103)

Blue

2.54 (0.100)

3.81 (0.150)

Yellow

Installation Data: Wire Size Range of Crimp Splicer

Two Wires

Three Wires

Minimum

Maximum

Minimum

Maximum

2 x 24

2 x 20

3 x 24

3 x 22

2 x 22

2 x 16

3 x 22

3 x 18

APPLICATION

1. These parts are designed to provide an immersion resistant in-line splices of 2 or 3 to 2 or 3 wires falling within

the size range listed above, having insulations rated for at least 135C.

2. Parts are available only as an assembly of one of each Item #1 and Item #2.

3. Crimp splicer may be installed with Raychem AD-1377 crimp tool or equivalent.

4. Inside diameter and outside diameter of splice are to be measured in crimp area, 2.54 to 5.08 (0.100 to 0.200)

from ends of part. Slight burr permitted on parted surfaces.

5. Acceptance sampling shall be in accordance with paragraph 4.6.1 of MIL-T-7928.

6 . Packing and packaging shall be in accordance with Section 5, Level C, of MIL-T-7928.

7. This document takes precedence over documents referenced herein.

1.0

TEST ASSEMBLIES

TE Connectivity

305 Constitution Drive

Menlo Park, CA 94025, USA

TITLE :

Raychem

Products

DOCUMENT NO.:

DATE:

IN-LINE SPLICE SEALING

SYSTEM, MULTI-WIRE

UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.

INCHES DIMENSIONS ARE BETWEEN BRACKETS.

TOLERANCES:

ANGLES: N/A

TE Connectivity reserves the right to amend this

0.00 N/A

drawing at any time. Users should evaluate the

0.0 N/A

ROUGHNESS IN

suitability of the product for their application.

0 N/A

MICRON

DRAWN BY:

REPLACES:

DCR NUMBER:

D-436-42/-43

DOC ISSUE:

15-Apr-11

PROD. REV.

SCALE:

SIZE:

2

SHEET:

M. FORONDA

N/A

D001303

SEE TABLE

None

A

1 of 4

If this document is printed it becomes uncontrolled. Check for the latest revision.