P6SMB SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
VOLTAGE
5.5 to 214 Volts
PEAK PULSE POWER
600 Watts
SMB/DO-214AA
Unit: inch (mm)
FEATURES
.155(3.94)
.130(3.30)
.083(2.11)
.075(1.91)
• For surface mounted applications in order to optimize board space.
• Low profile package
• Built-in strain relief
• Glass passivated junction
• Low inductance
• Typical I
D
less than 1.0µA above 10V
• Plastic package has Underwriters Laboratory
Fammability Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• In compliance with EU RoHS 2002/95/EC directives
.185(4.70)
.160(4.06)
.012(.305)
.006(.152)
.096(2.44)
.083(2.13)
MECHANICAL DATA
• Case: JEDEC DO-214AA ,Molded plastic over passivated junction
• Terminals: Solder plated,solderable per MIL-STD-750,Method 2026
• Polarity: Color band denotes positive end (cathode)
• Standard Packaging:12mm tape (EIA-481)
• Weight: 0.003 ounce, 0.093 gram
.050(1.27)
.030(0.76)
.008(.203)
.002(.051)
.220(5.59)
.200(5.08)
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
R ating
Peak Pulse Power D i ssi pati on on 10/1000uS waveform (Notes 1,2, Fi g.1)
Peak Forward Surge C urrent 8.3ms si ngle half si ne-wave
superi mposed on rated load (JED EC Method) (Notes 2,3)
Peak Pulse C urrent on 10/1000us waveform(Note 1)Fi g.3
Operati ng Juncti on and Storage Temperature Range
Symbol
P
PPM
I
FSM
I
PPM
T
J
,T
STG
Value
600
100
see Table 1
-55 to +150
Uni ts
Watts
Amps
Amps
O
C
NOTES:
1. Non-repetitive current pulse, per Fig.3 and derated above T
A
= 25
O
C per Fig. 2.
2. Mounted on 5.0mm
2
(0.13mm thick) land areas.
3. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute
maximum.
STAD-MAY.25.2007
PAGE . 1
PANJIT [ PAN JIT INTERNATIONAL INC. ]
