Model 5307 50 Ω Male BNC Connector and Assembly
Instructions
ASSEMBLY INSTRUCTIONS
Figure #1
1. Cut cable to length and strip per
dimensions:
Figure #3
4. Install the metal spacer and rear
•
•
outer jacket: 0.320” (8.128 mm)
inner conductor: 0.140” (3.556 mm)
2. Load the clamp nut, washer and V-Gasket
on to the cable as shown in Figure #1.
insulator. Solder the center contact in
place. Make sure the contact is
completely seated against the rear
insulator (see Figure #3).
Figure #2
Figure #4
3. Install the braid clamp onto the cable and
fold the braid back flat as shown in Figure
#2. Make sure that all of the individual
strands of braid are flat against the braid
clamp.
5. Place the front insulator into the
connector housing. The open end of the
insulator should face the front of the
connector housing (see Figure #4).
Sales:
800-490-2361
Fax:
Technical Support:
800-241-2060
or e-mail us at
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm),
.xxx = ± .005” (,127 mm). All specifications are to the latest revisions.
Specifications are subject to change without notice. Registered trademarks
are the property of their respective companies.
888-403-3360
technicalsupport@pomonatest.com
Where to Buy: www.pomonaelectronics.com
Copyright © 2005 07/2005 2391542 D-ENG-N Rev A Page 2 of 3