PE426482
SP8T RF Switch
Table 3 • PE426482 Electrical Specifications (Cont.)
Parameter
Path
Condition
Min
Typ
Max
Unit
Input IP2
RFC–RFX
RFC–RFX
100 MHz–8 GHz
105
60
dBm
dBm
ns
Input IP3
100 MHz–8 GHz
RF TRISE/TFALL
10%/90% RF
100
870
227
130
1400
290
Settling time
Switching time
Notes:
50% CTRL to 0.05 dB final value
50% CTRL to 90% or 10% of RF
ns
ns
1) Insertion loss and isolation performance can be improved by a good RF ground on the LS pin (pin 1).
2) Defined with S-parameters, relative insertion phase (RFX–RF1) = ∠S
– ∠S , where incident Port-1 is RFC, response Port-2 = RF1, and
21
(x+1)1
response Port-(x+1) = RFx.
3) The input 1dB and 0.1dB compression point are linearity figures of merit. Refer to Table 2 for the RF input power (50Ω).
Switching Frequency
Thermal Data
Psi-JT (ΨJT), junction top-of-package, is a thermal
metric to estimate junction temperature of a device on
the customer application PCB (JEDEC JESD51-2).
The PE426482 has a maximum 25 kHz switching
frequency. Switching frequency describes the time
duration between switching events. Switching time is
the time duration between the point the control signal
reached 50% of the final value and the point the
output signal reaches within 10% or 90% of its target
value.
ΨJT = (TJ – TT)/P
where
ΨJT = junction-to-top of package characterization
parameter, °C/W
Spurious Performance
The PE426482 spur fundamental occurs around
5 MHz. Its typical performance is –162 dBm/Hz, with
30 kHz bandwidth.
TJ = die junction temperature, °C
TT = package temperature (top surface, in the
center), °C
P = power dissipated by device, Watts
Hot-Switching Capability
The maximum hot switching capability of the
PE426482 is 18 dBm above 100 MHz. Hot switching
occurs when RF power is applied while switching
between RF ports.
Table 4 • Thermal Data for PE426482
Parameter
Typ Unit
23
63
°C/W
°C/W
ΨJT
ΘJA, junction-to-ambient thermal resistance
DOC-77476-3 – (03/2017)
Page 9
www.psemi.com