MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Order this document
by H11L1/D
GlobalOptoisolator™
[IF(on) = 1.6 mA Max]
6-Pin DIP Optoisolators
Logic Output
The H11L1 and H11L2 have a gallium arsenide IRED optically coupled to a
high–speed integrated detector with Schmitt trigger output. Designed for
applications requiring electrical isolation, fast response time, noise immunity
and digital logic compatibility.
•
•
•
•
•
•
Guaranteed Switching Times — ton, toff
<
4
µs
Built–In On/Off Threshold Hysteresis
High Data Rate, 1 MHz Typical (NRZ)
Wide Supply Voltage Capability
Microprocessor Compatible Drive
To order devices that are tested and marked per VDE 0884 requirements, the
suffix ”V” must be included at end of part number. VDE 0884 is a test option.
Applications
•
Interfacing Computer Terminals to Peripheral Equipment
•
Digital Control of Power Supplies
•
Line Receiver — Eliminates Noise
•
Digital Control of Motors and Other Servo Machine Applications
•
Logic to Logic Isolator
•
Logic Level Shifter — Couples TTL to CMOS
MAXIMUM RATINGS
(TA = 25°C unless otherwise noted)
Rating
INPUT LED
Reverse Voltage
Forward Current — Continuous
Forward Current
— Peak
Pulse Width = 300
µs,
2% Duty Cycle
LED Power Dissipation @ TA = 25°C
Derate above 25°C
OUTPUT DETECTOR
Output Voltage Range
Supply Voltage Range
Output Current
Detector Power Dissipation @ TA = 25°C
Derate above 25°C
TOTAL DEVICE
Total Device Dissipation @ TA = 25°C
Derate above 25°C
Maximum Operating Temperature(2)
Storage Temperature Range(2)
Soldering Temperature (10 s)
PD
TA
Tstg
TL
250
2.94
– 40 to + 85
– 55 to +150
260
mW
mW/°C
°C
°C
°C
Vo
VCC
IO
PD
0 –16
3 –16
50
150
1.76
Volts
Volts
mA
mW
mW/°C
VR
IF
6
60
1.2
120
1.41
Volts
mA
Amp
mW
mW/°C
Symbol
Value
Unit
[IF(on) = 10 mA Max]
H11L1 *
H11L2
*Motorola Preferred Device
STYLE 5 PLASTIC
6
1
STANDARD THRU HOLE
CASE 730A–04
SCHEMATIC
1
2
3
6
5
4
PIN 1.
2.
3.
4.
PD
ANODE
CATHODE
NC
OPEN COLLECTOR
OUTPUT
5. GND
6. VCC
Isolation Surge Voltage
VISO
7500
Vac(pk)
(Pk ac Voltage, 60 Hz, 1 Second Duration)(1)
1. Isolation surge voltage is an internal device dielectric breakdown rating.
1.
For this test, Pins 1 and 2 are common, and Pins 4, 5 and 6 are common.
2. Refer to Quality and Reliability Section in Opto Data Book for information on test conditions.
Preferred
devices are Motorola recommended choices for future use and best overall value.
GlobalOptoisolator is a trademark of Motorola, Inc.
REV 1
©
Motorola
Inc. 1995
Motorola,
Optoelectronics Device Data
1