欢迎访问ic37.com |
会员登录 免费注册
发布采购

HVR2 参数 Datasheet PDF下载

HVR2图片预览
型号: HVR2
PDF下载: 下载PDF文件 查看货源
内容描述: UHF窄带调频振动耐多通道接收机 [UHF Narrow Band FM Vibration Resistant Multi Channel Receiver]
分类和应用: 接收机
文件页数/大小: 7 页 / 421 K
品牌: RADIOMETRIX [ RADIOMETRIX LTD ]
 浏览型号HVR2的Datasheet PDF文件第1页浏览型号HVR2的Datasheet PDF文件第2页浏览型号HVR2的Datasheet PDF文件第3页浏览型号HVR2的Datasheet PDF文件第4页浏览型号HVR2的Datasheet PDF文件第5页浏览型号HVR2的Datasheet PDF文件第7页  
Antenna requirements
Three types of integral antenna are recommended and approved for use with the module:
A)
Whip
This is a wire, rod ,PCB track or combination connected directly to RF pin of the module.
Optimum total length is 16.4cm (1/4 wave @ 433MHz). Keep the open circuit (hot) end
well away from metal components to prevent serious de-tuning. Whips are ground plane
sensitive and will benefit from internal 1/4 wave earthed radial(s) if the product is small
and plastic cased
Wire coil, connected directly to RF pin, open circuit at other end. This antenna is very
efficient given it’s small size (20mm x 4mm dia.). The helical is a high Q antenna, trim
the wire length or expand the coil for optimum results. The helical de-tunes badly with
proximity to other conductive objects.
A loop of PCB track tuned by a fixed or variable capacitor to ground at the 'hot' end and
fed from RF pin at a point 20% from the ground end. Loops have high immunity to
proximity de-tuning.
B)
Helical
C)
Loop
Ultimate performance
Easy of design set-up
Size
Immunity proximity effects
Range open ground to similar antenna
A
whip
***
***
*
*
500m
B
helical
**
**
***
**
200
C
loop
*
*
**
***
100
The antenna choice and position directly controls the system range. Keep it clear of other metal in the
system, particularly the 'hot' end. The best position by far, is sticking out the top of the product. This is
often not desirable for practical/ergonomic reasons thus a compromise may need to be reached. If an
internal antenna must be used, try to keep it away from other metal components, particularly large
ones like transformers, batteries and PCB tracks/earth plane. The space around the antenna is as
important as the antenna itself.
0.5 mm enameled copper wire
close wound on 3.2 mm diameter former
RF
433 MHz = 24 turns
A. Helical antenna
Feed point 15% to 25% of total loop length
RF-GND
C2
C3
C4
C1
track width = 1mm
4 to 10 cm inside area
2
RF
B. Loop antenna
16.4cm
RF
wire, rod, PCB-track or a combination
of these three
433 MHz = 16.4 cm total from RF pin.
C. Whip antenna
Figure 6: Antenna types
Radiometrix Ltd
HVR2 Data Sheet
page 6