To configure the RPM3B the HyperTerminal should be set with the following settings.
Figure 6: Serial Port settings to use RPM3B Configurator
Hardware flow control should be disabled. Default baud rate of the RPM3B is 9600bps. However if the default
baud rate of the RPM3B is changed then the baud rate of the HyperTerminal should be matched or DEFAULT
pin should be pulled Low to force the RPM3B baud rate to 9600bps.
Figure 7: RPM3B configuration using HyperTerminal
User configurable parameters described in section 3.2 should be entered in the command prompt
>
followed
by Carriage Return (CR) key. Then SETUP should be pulled-up to VCC and RPM3B should be RESET to exit
the configurator and for the new parameters to be used by RPM3B.
Radiometrix Ltd.
UHF FM Radio Packet Modem
page 9