Notes:
When using an on-chip emulator (E7, E8) for H8/36057 and H8/36037 program development and
debugging, the following restrictions must be noted.
1. The
NMI
pin is reserved for the E7 or E8, and cannot be used.
2. Pins P85, P86, and P87 cannot be used. In order to use these pins, additional hardware must be
provided on the user board.
3. Area H'D000 to H'DFFF is used by the E7 or E8, and is not available to the user.
4. Area H'F780 to H'FB7F must on no account be accessed.
5. When the E7 or E8 is used, address breaks can be set as either available to the user or for use
by the E7 or E8. If address breaks are set as being used by the E7 or E8, the address break
control registers must not be accessed.
6. When the E7 or E8 is used,
NMI
is an input/output pin (open-drain in output mode), P85 and
P87 are input pins, and P86 is an output pin.
7. In on-board programming mode by boot mode, channel 1 (P21/RXD and P22/TXD) for SCI3
is used.
Related Manuals:
The latest versions of all related manuals are available from our web site.
Please ensure you have the latest versions of all documents you require.
http://www.renesas.com/
H8/36057 Group and H8/36037 Group manuals:
Document Title
H8/36057 Group, H8/36037 Group Hardware Manual
H8/300H Series Software Manual
Document No.
This manual
REJ09B0213
User's manuals for development tools:
Document Title
H8S, H8/300 Series C/C++ Compiler, Assembler, Optimizing Linkage Editor
User's Manual
H8S, H8/300 Series Simulator/Debugger User's Manual
H8S, H8/300 Series High-Performance Embedded Workshop 3 Tutorial
Document No.
REJ10B0058
REJ10B0211
REJ10B0024
H8S, H8/300 Series High-Performance Embedded Workshop 3 User's Manual REJ10B0026
Rev. 4.00 Mar. 15, 2006 Page vii of xxxii
RENESAS [ RENESAS TECHNOLOGY CORP ]
