Low Noise Amplifier
CL2701-L / CL2702-L
Product Features
• GaAs p-HEMT chip on board
• No matching circuit needed
• High Maximum input power(+25dBm)
• High IP3 & Low Noise
• Single Supply Voltage (+5V)
• Surface Mount Hybrid Type
• Tape & Reel Packaging
• Small Size, High Heatsink
• Alumina Substrate
• Pb Free / RoHS Standard
Applications
• Repeater
• Base Station
• RF Sub-Systems
• WiMAX, WiBro, Radar system
Package : CP-16A
Descriptions
RFHIC’s LOW Noise Amplifier series are all hybrid LNA type products which includes all matching for the convenience of
customers. CL series are focused on giving lowest noise possible. The structure of the device is built with GaAs p-HEMT die
attached on a ceramic thick film substrate. The device is still smaller than the area one would use for the application notes all
together. Depending on the part number, one can use this in different frequency applications. All LNA hybrids are possible to have
custom frequency & spec without any additional NRE cost involved.
All RFHIC products are RoHS compliant.
Electrical Specifications
Parameter
Frequency Range
Small Signal Gain (S
21
)
Gain Flatness
Input Return Loss (S
11
)
Output Return Loss (S
22
)
1dB Compression Point (P
1
dB)
Output 3
rd
Order Intercept Point
(OIP3) (TYP.)
Noise Figure (TYP.)
DC Supply Current (Vdc=+5V)
Units
MHz
dB
dB
dB
dB
dBm
dBm
dB
mA
CL2701-L
2300~2700
12@2500MHz
±1.5
-18
-10
16
28
0.9
45
2700~3100
10.5@2900MHz
±1.0
-15
-15
16
28
0.9 ~ 1.0
45
CL2702-L
2300~2700
2700~3100
12.5@2500MHz 11.5@2900MHz
±1.5
-18
-10
20
33
0.9
100
±1.0
-15
-15
20
33
0.9 ~ 1.0
100
Test Condition
①
Supply voltage = +5V, 50ohm System, Ta = 25℃
②
OIP3 is measured with two tones, at an output power of +0dBm/tone separated by 1MHz.
▪
Tel : 82-31-250-5011
▪
rfsales@rfhic.com
page 1/5
▪
All specifications may change without notice.
▪
Version 6.2
RFHIC [ RFHIC ]
