Wideband LNA
Product Features
• GaAs p-HEMT chip on board
• No matching circuit needed
• High Maximum input power(+25dBm)
• High IP3 & Low Noise
• Single Supply Voltage (+5V)
• Surface Mount Hybrid Type
• Tape & Reel Packaging
• Small Size, High Heatsink
• Alumina Substrate
• Pb Free / RoHS Standard
WL1008-L / WL2208-L
WL1015-L / WL2215-L
Applications
• 2G & 3G Repeater
• Base Station
• PCS, CDMA, W-CDMA
• GSM, DCS, UMTS
• RF Sub-Systems
Package : CP-16A
Descriptions
RFHIC’s LOW Noise Amplifier series are all hybrid LNA type products which includes all matching for the convenience of
customers. WL series are a wideband LNA used for up to 50~2200MHz. The structure of the device is built with GaAs p-HEMT
die attached on a ceramic thick film substrate. The device is still smaller than the area one would use for the application notes all
together. Depending on the part number, one can use this in different frequency applications. All LNA hybrids are possible to have
custom frequency & spec without any additional NRE cost involved.
All RFHIC products are RoHS compliant.
Electrical Specifications
Parameter
Frequency Range
Small Signal Gain (S
21
)
Gain Flatness
Input Return Loss (S
11
)
Output Return Loss (S
22
)
1dB Compression Point (P
1
dB)
Output 3
rd
Order Intercept Point
(OIP3) (TYP.)
Noise Figure (TYP.)
DC Supply Current (Vdc=+5V)
Units
MHz
dB
dB
dB
dB
dBm
dBm
dB
mA
WL1008-L
50~1000
16
±1.0
-15
-5
19
31
1.5
100
WL2208-L
50~2200
15
±2.0
-10
-5
20
31
1.5
100
WL1015-L
50~1000
16
±1.0
-15
-5
21
35
1.7
160
WL2215-L
50~2200
15
±2.0
-10
-5
21
35
1.7
160
Test Condition
①
Supply voltage = +5V, 50ohm System, Ta = 25
℃
②
OIP3 is measured with two tones, at an output power of +0dBm/tone separated by 1MHz.
▪
Tel : 82-31-250-5011
▪
rfsales@rfhic.com
page 1/4
▪
All specifications may change without notice.
▪
Version 6.1
RFHIC [ RFHIC ]
