SF1063A
•
•
•
•
•
Designed for CATV Applications (Pilot Tone)
Low Insertion Loss
9.1 x 7.1 mm Surface-Mount Case
Unbalanced Input and Output
Complies with Directive 2002/95/EC (RoHS)
Pb
549.00 MHz
SAW Filter
Value
+10
30
-40 to +85
260°C for 30 s
Units
dBm
VDC
°C
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Suitable for lead-free soldering - Max Soldering Profile
SM9171-10
Electrical Characteristics
Characteristic
Nominal Center Frequency
Passband
Insertion Loss at fc
0.5 dB Passband
3 dB Passband
Amplitude Ripple over fc ±100 kHz
Rejection
529.04 MHz to 545.75 MHz
551.4 MHz to 569.04 MHz
Ultimate
Operating Temperature Range
Impedance Matching to 50
Ω
unbalanced
Case Style
Lid Symbolization (XX = 2 character date code)
T
A
1
-20
External L-C
SM9171-10 9.1 x 7.1 mm Nominal Footprint
RFM SF1063A XX
1, 2, 3
40
35
50
+85
°C
dB
Sym
f
C
IL
BW
0.5
BW
3
1, 2
±100
±630
0.5
Notes
1
Min
Typ
549.000
7.5
Max
9.0
Units
MHz
dB
kHz
dB
P-P
ns
P-P
Electrical Connections
Connection
Port 1 Hot
Port 1 Gnd Return
Port 2 Hot
Port 2 Gnd Return
Case Ground
Terminals
10
1
5
6
All others
Notes:
1. Unless noted otherwise, all specitication apply over the operating temperature range with filter soldered to the specified demonstration board with
impedanced matching to 50
Ω
network analyzer.
2. Unless noted otherwise, all frequency specitications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42 for details.
4. “LRIP” or “L” after the part number indicates “low rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port
1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9. Electrostatic Sensitive Device. Observe precautions for handling.
RF Monolithics, Inc.
Phone: (972) 233-2903
Fax: (972) 387-9148
RFM Europe
Phone: 44 1963 251383
Fax: 44 1963 251510
©2001 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
E-mail: info@rfm.com
http://www.rfm.com
SF1063A-112904
Page 1 of 3
RFM [ RF MONOLITHICS, INC ]
