Preliminary
SF1216D
• CDMA 450 F-Band RF SAW Filter
• 3.8 x 3.8 x 1.4 mm Surface-mount Package
• Complies with Directive 2002/95/EC (RoHS)
Pb
Value
+30
30
-40 to +85
260°C for 30 s
481.2 MHz
SAW Filter
Units
dBm
VDC
°C
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage between any Two Terminals
Storage Temperature Range
Suitable for Lead-free Soldering - Maximum Soldering Profile
SM3838-6
Electrical Characteristics
Characteristic
Nominal 1 dB Center Frequency
Passband Insertion Loss
VSWR
Rejection
479.0 to 483.5 MHz
479.0 to 483.5 MHz
0.3 to 467.0 MHz
489.0 to 493.5 MHz
493.5 to 1700 MHz
1700 to 2000 MHz
Operating Temperature Range
Impedance at f
c
Source, single ended
Load, single ended
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
T
A
1
1, 2, 3
25
30
23
18
-30
50 ohm
50 ohm
SM3838-6 3.8 x 3.8 mm Nominal Footprint
645, YWWS
1000 Pieces/Reel
3000 Pieces/Reel
Sym
f
C
IL
Notes
1
Min
Typ
481.2
1.8
1.5:1
27
49
27
20
Max
2.8
2:1
Units
MHz
dB
dB
+80
°C
Electrical Connections
Connection
Port 1
Port 2
Case Ground
Terminals
2
5
All others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42
for details.
"LRIP" or "L" after the part number indicates "low rate initial production"
5.
6.
and "ENG" or "E" indicates "engineering prototypes."
The design, manufacturing process, and specifications of this filter are
subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
7.
8.
4.
www.RFM.com E-mail: info@rfm.com
©2008 by RF Monolithics, Inc.
Page 1 of 5
SF1216D - 12/12/08