SF2001E
•
•
•
•
RF Filter for Mobile Communication Applications
No Matching Circuit Required
3.0 x 3.0 x 1.3 mm Package
Complies with Directive 2002/95/EC (RoHS)
Pb
Absolute Maximum Ratings
Rating
Maximum Input Power
DC Voltage on any Non-ground Terminal
Storage Temperature Range in Tape and Reel
Maximum Soldering Profile, 5 cycles/10 seconds maximum
1960 MHz
SAW Filter
Value
+10
0
-40 to +85
265
Units
dBm
VDC
°C
°C
SM3030-6
Electrical Characteristics
Characteristic
Nominal Operating Frequency
Passband Insertion Loss, 1930 -1990 MHz
Amplitude Ripple, 1930 -1990 MHz
Attenuation Referenced to 0 dB
DC to1850 MHz
1850 to 1910 MHz
2010 to 2040 MHz
2040 to 2070 MHz
2070 to 5000 MHz
5000 to 6000 MHz
VSWR, 1930 to 1990 MHz
Source impedance
Load impedance
Operating Temperature
Case Style
Lid Symbolization (Y=year, WW=week S=shift)
Z
S
Z
L
T
A
-30
20.0
10.0
4.5
20.0
22.0
10.0
32.0
21.0
10.0
50
29.0
15.0
1.7
50
50
+80
2.4
Ω
Ω
°C
dB
dB
dB
dB
dB
dB
Sym
f
C
IL
Notes
Min
Typ
1960
2.35
1.4
Max
4.0
2.4
Units
MHz
dB
dB
P-P
SM3030-6 3 x 3 mm Nominal Footprint
652 YWWS
Electrical Connections
Connection
Input
Output
Ground
Terminals
2
5
All others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42 for
details.
"LRIP" or "L" after the part number indicates "low rate initial production"
and "ENG" or "E" indicates "engineering prototypes."
5.
6.
The design, manufacturing process, and specifications of this filter are
subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
7.
8.
4.
www.RFM.com E-mail: info@rfm.com
©2009-2010 by RF Monolithics, Inc.
Page 1 of 5
SF2001E - 7/21/10
RFM [ RF MONOLITHICS, INC ]
