SF2006C
• SAW Filter for W-CDMA
• 5.0 X 5.0 X 1.7 mm Surface-Mount Case
• Complies with Directive 2002/95/EC (RoHS)
Maximum Rating
Rating
Input Power Level
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Pb
Value
10
-30 to +70
-30 to +70
190.00 MHz
SAW Filter
Units
dBm
°C
°C
SM5050-8
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss
6 dB Bandwidth
Group Delay Ripple
RMS Phase Linearity, f
C
± 2 MHz
Attenuation Referended to IL
MIN:
170 to 180 MHz, or (f
C
- 20 MHz) to (f
C
- 10 MHz)
180 to 185.5 MHz, or (f
C
-10 MHz) to (f
C
-4.5 MHz)
194.5 to 200 MHz, or (f
C
+ 4.5 MHz) to (f
C
+ 10 MHz)
200 to 210 MHz, or (f
C
+ 10 MHz) to (f
C
+ 20 MHz)
Ultimate Rejection
Lid Symbolization (Y=year, WW=week, S=shift)
27
25
25
27
34
31
30
33
50
RFM 734 YWWS
dB
Sym
f
C
IL
MIN
BW
Notes
Min
Typ
190
8.0
Max
10
150
8
Units
MHz
dB
MHz
ns
deg
4.8
5.73
70
6
Electrical Connections
Connection
Port 1
Port 2
Dot indicates Pin 1
Input
Output
Ground
Terminals
2
6
All others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42
for details.
"LRIP" or "L" after the part number indicates "low rate initial production"
and "ENG" or "E" indicates "engineering prototypes."
5.
6.
The design, manufacturing process, and specifications of this filter are
subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
7.
8.
4.
www.RFM.com E-mail: info@rfm.com
©2008-2010 by RF Monolithics, Inc.
Page 1 of 4
SF2006C - 6/14/10
RFM [ RF MONOLITHICS, INC ]
