SF2069A-2
• Low Insertion Loss
• Hermetic 13.3 x 6.5 mm Surface-mount Case
• Complies with Directive 2002/95/EC (RoHS)
Pb
96.0 MHz
SAW Filter
Value
+10
30
-40 to +85
265°C for 10 s
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Max. Soldering Profile
Units
dBm
VDC
°C
SMP53-S
Electrical Characteristics
Characteristic
Center Frequency ( @ 25°C )
Minimum Insertion Loss
1 dB Bandwidth
15 dB Bandwidth
Passband Variation (in 1dB Bandwidth)
Phase Linearity (Fc ±1.92 MHz)
Group Delay Variation (in 1 dB Bandwidth)
Absolute Delay
Change in Absolute Delay (from unit to unit)
Absolute Delay Variation (from -40°C to 55°C)
Rejection (40 to 87 MHz)
Rejection (111 to 150 MHz)
Source and Load Impedance
Temperature Coefficient
Ambient Temperature
Case Style
Lid Symbolization (YY = year, WW = week, D=day)
Sym
f
C
Notes
1
Min
95.9
5.00
Typ
96.0
14
5.60
7.50
0.5
5.2
50
1.4
0
8
48
48
50
-20
25
Max
96.1
15
8.00
1.0
8
80
3
10
15
Units
MHz
dB
MHz
MHz
dB p-p
deg p-p
ns p-p
us
ns
ns
dB
dB
Ω
ppm/°C
°C
-10
43
43
SMP-53-S 13.3 x 6.5 mm Nominal Footprint
RFM SF2069A-2 YYWWD
Electrical Connections
Connection
Port 1 Input
Port 2 Output
Case Ground
Terminals
1
6
2, 3, 4, 5, 7, 8, 9,10
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
4.
5.
6.
7.
8.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation from fc IL. Rejection in final user application is dependent on PCB layout and external impedance matching design. See
Application Note No. 42 for details.
Part to part absolute delay measurement records the absolute delay mean across 2 dB passband.
"LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes.”
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
www.RFM.com
E-mail: info@rfm.com
©2008 by RF Monolithics, Inc.
Page 1 of 4
SF2069A-2 - 7/25/08
RFM [ RF MONOLITHICS, INC ]
