SF2135A
•
•
•
•
•
Designed for Wide Channel IF Filtering
Low Insertion Loss
Hermetic 13.3 x 6.5 mm Surface-mount Case
Balanced or Single-ended Input and Output
Complies with Directive 2002/95/EC (RoHS)
Pb
96.0 MHz
SAW Filter
Value
+13
30
-40 to +85
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage Between any Two Terminals
Storage Temperature Range
Suitable for Lead-free Soldering - Maximum Soldering Profile
Units
dBm
VDC
°C
260 °C for 30 s
SMP-53
Electrical Characteristics
Characteristic
Center Frequency
1 dB Bandwidth
Insertion Loss
Relative Attenuation
91 to 94.5 MHz
97.5 to 98.5 MHz
10 to 60 MHz
76.8 MHz
132 to135 MHz
135 to 1000 MHz
Passband Amplitude Ripple
Group Delay Ripple
Operating Temperature
Terminating Source Impedance
Terminating Load Impedance
Impedance Matching to 50
Ω
Unbalanced
Case Style
Lid Symbolization (YY = year, WW = week)
95.2 to 96.8 MHz
95.2 to 96.8 MHz
1, 2, 3
1
-30
50
50
External L-C
SMP-53 13.3 x 6.5 mm Nominal Footprint
RFM SF2135A YYWW
Sym
f
C
BW
1
IL
Notes
1
1, 2,3
Min
1.56
6
6
55
55
55
35
Typ
96.0
1.80
11.8
9.5
11.5
72
72
74
58
0.9
62
Max
Units
MHz
MHz
15.0
dB
dB
dB
dB
dB
1.2
100
+85
dB
P-P
ns
P-P
°C
ohm
ohm
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
4.
5.
6.
7.
8.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
Part to part absolute delay measurement records the absolute delay mean across 1 dB passband.
"LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes.”
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
www.RFM.com E-mail: info@rfm.com
©2009 by RF Monolithics, Inc.
Page 1 of 4
SF2135A - 7/9/09
RFM [ RF MONOLITHICS, INC ]
