SF2160E
• RF SAW Filter, 2330 MHz, 60 MHz BW
• 3.0 x 3.0 x 1.4 mm Surface-mount Case
• Complies with Directive 2002/95/EC (RoHS)
Pb
2330 MHz
SAW Filter
Value
+10
3
-40 to +85
-50 to +95
-40 to +85
265
Absolute Maximum Ratings
Rating
Input Power
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Component Storage Temperature Range
Storage Temperature Range in Tape and Reel
Maximum Soldering Profile, 5 Cycles/10 seconds Maximum
Units
dBm
V
°C
°C
°C
°C
SM3030-6
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss
Amplitude Ripple:
2300 to 2360 MHz
2300 to 2320 MHz
2320 to 2340 MHz
2340 to 2360 MHz
Return Loss
Attenuation Referenced to 0 dB:
DC to 2085 MHz
2097 to 2235 MHz
2235 to 2256 MHz
Case Style
Lid Symbolization, Y=year, WW=week, S=shift, See note 4
25
25
15
30
36
29
dB
2300 to 2360 MHz
9
1.1
0.3
0.6
0.5
9.5
2
1
1
1
dB
dB
2300 to 2360 MHz
Sym
f
C
IL
Notes
Min
Typ
2330
2.4
Max
3.2
Units
MHz
dB
SM3030-6 3 x 3 x 1.4 mm Surface-Mount
826 // YWWS
Electrical Connections
Connection
Input
Output
Ground
Terminals
2
5
All others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42 for
details.
"LRIP" or "L" after the part number indicates "low rate initial production"
and "ENG" or "E" indicates "engineering prototypes."
5.
6.
The design, manufacturing process, and specifications of this filter are
subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc., are registered
trademarks of RF Monolithics, Inc.
2.
3.
7.
8.
4.
www.RFM.com E-mail: info@rfm.com
©2009-2010 by RF Monolithics, Inc.
Page 1 of 6
SF2160E - 7/19/10
RFM [ RF MONOLITHICS, INC ]
