SF2204E
• Low-loss SAW Filter
• Surface-mount 3.0 x 3.0 x 1.4 mm Package
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Solder Reflow Temperature, 10 seconds, 5 cycles maximum
Pb
1900 MHz
SAW Filter
Value
10
3
-20 to +70
-40 to +85
260
Units
dBm
V
°C
°C
°C
SM3030-6
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss, 1880 to 1920 MHz
Amplitude Ripple, 1880 to 1920 MHz
Group Delay Ripple, 1880 to 1920 MHz
Input VSWR, 1880 to 1920 MHz
Output VSWR, 1880 to 1920 MHz
Attenuation Referenced to 0 dB
0.3 to 1000 MHz
1000 to 1700 MHz
1700 to 1830 MHz
1970 to 2400 MHz
2400 to 3000 MHz
3000 to 4000 MHz
Source Impedance
Load Impedance
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
Z
S
Z
L
30
30
32
38
30
25
35
35
38
45
40
34
50
50
SM3030-6 3.0 x 3.0 mm Nominal Footprint
936, YWWS
500 Pieces/Reel
3000 Pieces/Reel
Ω
dB
Sym
F
C
IL
Notes
Min
Typ
1900
2.7
1.0
10
1.5:1
1.5:1
Max
3.5
1.5
40
2.0:1
2.0:1
Units
MHz
dB
dB
P-P
ns
P-P
Electrical Connections
Connection
Input
Output
Ground
Terminals
5
2
All Others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
4.
5.
6.
7.
8.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
"LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc
www.RFM.com E-mail: info@rfm.com
©2010 by RF Monolithics, Inc.
Page 1 of 7
SF2204E - 8/10/10
RFM [ RF MONOLITHICS, INC ]
