ZULU
Trans-
RF Trans-controller
•
•
•
•
•
RF Transceiver combined with
Onboard 8051 µcontroller
Upto 2km Range
Operates from 3.6 - 0.9V
Dimensions: 25 x 11mm
Transceiver Features
•
Frequency range = 433,470,868,915MHz ISM Band
•
Sensitivity = –121 dBm
•
FSK, GFSK, and OOK modulation
•
Max output power = +20 dBm
•
RF power consumption
⇒
18.5mA receive
⇒
18 mA @+1 dBm transmit
⇒
40mA @+13 dBm transmit
⇒
100mA @+20 dBm transmit
•
Data rate = 0.123 to 256 kbps
•
Auto-frequency calibration (AFC)
•
transmit/receive switch control
•
Programmable packet handler
•
TX and RX 64 byte FIFOs
•
Frequency hopping capability
•
On-chip crystal tuning
Digital Peripherals
•
19 or 16 port I/O plus 3 GPIO pins; Hardware enhanced
•
UART, SPI, and I2C serial ports available concurrently
Low power 32-bit SmaRTClock
Features
•
Ultra Low Power: 0.9 to 3.6 V Operation
•
Typical sleep mode current < 0.1
µA;
retains state and RAM
•
•
Less than 1
µA
with RTC running and radio state retained
•
Two built-in brown-out detectors cover sleep and active
modes
contents over full supply range; fast wakeup of < 2
µs
Less than 600 nA with RTC running
10-
10-Bit Analog to Digital Converter
•
Up to 300 ksps
•
Up to 18 external inputs
•
External pin or internal VREF (no external capacitor required)
•
Built-in temperature sensor
•
External conversion start input option
•
Auto burst mode c/w 16-bit auto averaging accumulator
Dual Comparators
•
Programmable hysteresis and response time
•
Configurable as interrupt or reset source
•
Low current (< 0.5
µA)
On-
On-Chip Debug
•
On-chip debug circuitry facilitates full-speed, non-intrusive in-
system debug (No emulator required)
•
Provides breakpoints, single stepping
Four general purpose 16-bit counter/timers; six channel
programmable counter array (PCA)
•
Inspect/modify memory and registers
High-
High-Speed 8051
µC
Core
C
•
Pipelined instruction architecture; executes 70% of instruc-
tions in 1 or 2 system clocks
•
Up to 25 MIPS throughput with 25 MHz clock
Clock Sources
•
Precision internal oscillators: 24.5 MHz with ±2% accu-
•
•
SmaRTClock oscillator: 32.768 kHz crystal or self-
•
racy supports UART operation; spread-spectrum mode
for reduced EMI; Low power 20 MHz internal oscillator
External oscillator: Crystal, RC, C, CMOS clock
oscillate
Can switch between clock sources on-the-fly; useful in
power saving modes and in implementing various power
saving modes
Memory
•
4352 bytes internal data RAM (256 + 4096)
•
64 kB Flash; In-system programmable in 1024-byte sec-
tors—1024 bytes are reserved in the 64 kB device
I/O Port
•
19 or 20 port I/O (5 V tolerant except for GPIO_2)
DS-ZULU-1