GB-2423.2 参数 Datasheet PDF下载

6.3.4

Label

MODEL:

Po:

M . Date:

QTY:

pcs

LOT NO :

（1）

A label on the clean-

bag

QTY(PCS)

mW

CHIP LOT

TO：

TYPE

QTY

LOT No.

M.Date

C/No.

G.WT

N.WT

L

W

H

38

29

14.5

cm

cm

cm

7. Operation note

7.1 Absolute maximum ratings

If an excessively large current flows in a laser diode, a large optical output will occur and the

emitting facet may sustain damage.This optical damage can occur even with momentary over-current.

For this reason, absolute maximum ratings which must not be exceeded even momentarily have been

established. Exercise particular caution with respect to the drive voltage supply and static electricity.

We guarantee use within the absolute maximum ratings. These ratings are established for a case

temperature of 25℃. As the temperature of a laser diode increases, its maximum output will decrease

and the operating range will shrink.Even when operated within the absolute maximum ratings,

operation at high temperature will result in a shorter life than operation at low temperature. For this

reason, the design should include sufficient margin for heat radiation and light output.

7.2 Heat radiation conditions

Like other semiconductors, prolonged operation of a laser diode will cause heat to build up at

junctions and increased case temperature. For this reason, attach aluminum, copper (or other) heat

sinks (at least 30

×

30

×

3mm) to the stem of the laser.

7.3 Protection against damage due to electrostatic discharge and other current surges

Electrostatic discharge and other current surges can cause deterioration and damage in laser

diodes, resulting in reduced reliability ,We advise taking the following protective measures :

7.3.1 Ground the device and circuits. Install surge filters, surge reduction transformers, or other

electrostatic discharge protectors in the power supply inputs.

7.3.2 When working with laser diodes wear anti-static clothing, including footwear and caps. Materials

should be selected carefully. Grounded wrist should always be worn while working with laser diodes,

and the strap should be grounded through a 1 MΩresistance.

03.08.2010

eld83npt5.doc

8 of 10