Transient Voltage Suppressors - 5.0SMDJ Series
UNI
Features
1. Halogen-free
2. Rohs compliant
3. Typical maximum temperature coefficient
BR
BR
4. ΔV = 0.1% x V @25°C x ΔT
5. Glass passivated Chip junction in DO-214AB package
6. 5000W peak pulse capadility at 10×1000μs waveform, repetition rate (duty
cycles):0.01%
BI
7. Fast response time:typically less than 1.0ps from 0 Volts to BV min
8. Excellent clamping capability
9. Low incremental surge resistance
10. Typical IR less than 5μA above 12V
BI
Cathode
Anode
11. High temperature soldering guaranteed: 260°C/40 seconds / 0.375”,
12. (9.5mm) lead length, 5lbs., (2.3kg) tension
13. Plastic package has underwriters laboratory flammability classification
94v-0
UNI
Applications
TVS devices are ideal for the protection of I/O interfaces,VCC bus and other vulnerable circuits used in telecom, computer,
industrial and consumer electronic applications.
Mechanical Characteristics
Rating
Symbol
PPPM
PD
Value
5000
6.5
Units
Watts
Watts
Amps
Peak Pulse Power Dissipation at TA=25°C by 10/1000μs
Waveform (Fig.2)(Note 1), (Note 2)
Power Dissipation on Infinite Heat
Sink at TA=50°C
Peak Forward Surge Current, 8.3ms
Single Half Sine Wave (Note 3)
IFSM
300
Maximum Instantaneous Forward Voltage at 100A for
Unidirectional Only
VF
5.0
V
Operating junction and Storage Temperature Range.
Typical Thermal Resistance Junction to Lead
T T
-55°C to 150°C
°C
,
J
STG
RuJL
RuJA
15
75
°C/W
°C/W
Typical Thermal Resistance Junction
to Ambient
Notes:
1. Non-repetitive current pulse , per Fig. 4 and derated above TA = 25°C per Fig. 3.
2. Mounted on copper pad area of 0.31x0.31” (8.0 × 8.0mm) to each terminal.
3. Measured on 8.3ms single half sine wave or equivalent square wave for unidirectional device only,duty cycle=4 per minute
maximum.
Specifications are subject to change without notice.
Circuit Protection
System
Page:1
Please refer to http://www.ruilon.com for current information.