Capacity versus current at 20°C
™
MP 174565 Integration
C/5 (0.96 A) C/2 (2.4 A)
C (4.8 A)
2C (9.6 A)
Battery assembly
In order to operate properly, individual Li-ion cells are
mechanically and electrically integrated in battery assemblies
specific to each application. The battery assembly
incorporates electronics for performance, thermal and
safety management.
Technology
Graphite-based anode
Lithium Cobalt oxide-based cathode
Electrolyte: organic solvents
Built-in redundant safety protections
(shutdown separator, circuit breaker, safety vent)
Batteries assembled from MP cells feature an electronic
•
•
•
•
Capacity (Ah)
•
Typical discharge profiles (0.96 A - C/5 rate)
protection circuit
Cover
(aluminium)
Negative terminal
Insulator
-20°C
+60°C
+20°C
Circuit breaker
& Safety vent
Positive terminal
Negative tab
Separator
Electrolyte
filling hole
Can
(aluminium)
-40°C
-30°C
Jelly roll
Capacity (Ah)
Charge characteristics to 4.2 V at +20°C
Built-in protection devices ensure safety in case of:
Exposure to heat
Exposure to direct sunlight for extended periods of time
Short circuit
Overcharge
Overdischarge
•
•
•
•
•
When handling Saft MP batteries:
Do not disassemble
Do not remove the protection circuit
Do not incinerate
•
•
•
C (4.8 A) C/2 (2.4 A) C/5 (0.96 A)
Transportation and storage:
Store in a dry place at a temperature preferably not
•
°
exceeding 30 C
For long-term storage, keep the battery within a
30 ± 15 % state of charge
•
Charge time (hours)
Saft
Specialty Battery Group
12, rue Sadi Carnot
93170 Bagnolet - France
Tel.:+33 (0)1 49 93 19 18
Fax:+33 (0)1 49 93 19 69
Doc. N 54065-2-0909
Information in this document is subject to change without notice
and becomes contractual only after written confirmation by Saft.
º
313 Crescent Street
Valdese, NC 28690 - USA
Tel.:+1 (828) 874 41 11
Fax:+1 (828) 879 39 81
Published by the Communications Department.
Photo credit: Saft.
Sociéte´ anonyme au capital de 31 944 000
RCS Bobigny B 383 703 873
www.saftbatteries.com
Produced by Arthur Associates Limited.