Mounting/Disassembly
2
WARNING
The LOGO!Power power supplies are built-in units. They must be installed in a casing or
control cabinet to which only qualified personnel have access.
The devices can be snapped onto standard mounting rail EN 60715 35x7.5/15 for installation
in a control cabinet.
Installation
To mount the device, position it with the mounting rail guideway at the upper edge of the DIN
rail and press down to lock it into place. If this is too difficult, press slider
①
at the same
time, as described for "Disassembly".
Deinstalling
To remove, pull up the slider
①
using a screwdriver
②
and disengage the device at the
bottom edge of the DIN rail. Then you can remove the device from the upper edge of the DIN
rail.
Figure 2-1
Deinstalling
WARNING
If the device is to be used in a hazardous area (Ex II 3G Ex nA IIC T3) it must be installed
in a distributor box with degree of protection IP54 or higher.
LOGO!Power
Operating Instructions, 02.2011, C98130-A7560-A999-1-7619
13