Si1000/1/2/3/4/5
29. C2 Interface
Si1000/1/2/3/4/5 devices include an on-chip Silicon Labs 2-Wire (C2) debug interface to allow Flash pro-
gramming and in-system debugging with the production part installed in the end application. The C2 inter-
face uses a clock signal (C2CK) and a bi-directional C2 data signal (C2D) to transfer information between
the device and a host system. See the C2 Interface Specification for details on the C2 protocol.
29.1. C2 Interface Registers
The following describes the C2 registers necessary to perform Flash programming through the C2 inter-
face. All C2 registers are accessed through the C2 interface as described in the C2 Interface Specification.
C2 Register Definition 29.1. C2ADD: C2 Address
Bit
Name
Type
Reset
0
0
0
0
7
6
5
4
3
2
1
0
C2ADD[7:0]
R/W
0
0
0
0
Bit
Name
Function
The C2ADD register is accessed via the C2 interface to select the target Data register
for C2 Data Read and Data Write commands.
7:0 C2ADD[7:0]
C2 Address.
Address
0x00
0x01
0x02
0xB4
Description
Selects the Device ID register for Data Read instructions
Selects the Revision ID register for Data Read instructions
Selects the C2 Flash Programming Control register for Data
Read/Write instructions
Selects the C2 Flash Programming Data register for Data
Read/Write instructions
Rev. 1.0
371
SILABS [ SILICON LABORATORIES ]
