SC8204
Working mode two(SELECT pin disconnect anything): press “
ON/OFF”key or “
ON/SPEED”,low wind start-up,
follow successive pressing of “
SPEED” or “
ON/SPEED” key, it will operate as strong wind, low wind, strong
wind,strong wind … … go along with cycle. LED will on/off with key.
“TIMER” key:
This key used to set the preset off time.
Type mark with “ means have four section time output (0.5, 1, 2, 4hours) accumulated.
A4”
Type mark with “ means have four section time output (0.5, 1, 2, 4hours) non-accumulated.
N4”
Type mark with “ means have three section time output (1, 2, 4 hours) non-accumulated.
N3”
Type mark with “ means have four section time output (1, 2, 4, 8 hours) non-accumulated.
N8”
When fan is in the time mode, LED will indicate the remain time, means the fan will stop after the display time.
“SWING1” key:
If pressed when fan is in the operate mode, it can control the fan swing, it is invalid when fan stopped.
“SWING2” key: (the same as “SWING1” key)
If pressed when fan is in the operate mode, it can control the fan swing, it is invalid when fan stopped.
“LIGHT” key:
It is used to control light, is independent of the operate mode. “
OFF”and “
ON/OFF”key too control light.
Buzzer output:
a) Turn on send out “
Bi-Bi”
b) Turn off send out “
Bi-“
c) Other available operate (include key press and remote controller receive) send out “
Bi”
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http: www.silan.com.cn
REV:1.0
2004.08.03
Page 6 of 9
SILAN [ SILAN MICROELECTRONICS JOINT-STOCK ]
