Silan
Semiconductorsꢀ
SC84510
ꢀ
The following describes valid command:
(a) Reset (FF)
SC84510 operation:
a Completion the reset.
b Transmitted FA, AA, 00 to the system.
c Set default:
sampling rate: 100 reports/s
non-auto-speed
stream mode
2 dots/count
disable
(b) Resend (FE)
a. Any time SC84510 receives an invalid command; it returns a Resend command to the system.
b. When SC84510 receives a Resend command, it retransmits its last packet of data. If the last packet was
a Resend command, it transmits the packet just prior to the Resend command.
c. In stream mode if a Resend command is received by SC84510 immediately following a 3-byte data
packet transmission to the system.
(c) Set Default (F6)
The command reinitializes all conditions to the power-on defaults.
(d) Disable (F5)
This command is used in the stream mode to stop transmissions from SC84510.
(e) Enable (F4)
Begins transmissions, if in stream mode.
(f) Set Sampling Rate (F3, XX)
In the stream mode, this command sets the sampling rate to the value indicated by byte hex XX, shown in
following:
Second byte XX
Sample Rate
10/sec
0A
14
28
3C
50
64
C8
20/sec
40/sec
60/sec
80/sec
100/sec
200/sec
HANGZHOU SILAN MICROELECTRONICS JOINT-STOCK CO.,LTD
ꢀ
Rev: 1.0
2000.12.31ꢀ
9
SILAN [ SILAN MICROELECTRONICS JOINT-STOCK ]
