CINT3110
110W Triple Output
Industrial Series
General Specifications
(continued)
Inrush Current
264Vac, cold start: will not exceed 45A
Signals
Overload
Protection
Short Circuit
Protection
Overvoltage
Protection
Switching
Frequency
Isolation
Operating
Temperature
Temperature
Derating
Storage
Temperature
Altitude
AC Power Fail, DC OK
Input Fuses
Earth Leakage
Current
Efficiency
F1, F2: 2.5A, 250Vac fuses provided on all
models
<290μA@264Vac, 60Hz, NC
150%-300% above rating for V2 & V3, 110%-
200% for V1. Hiccup Mode
Provided - no damage will occur if the output is
shorted.
87% typical at 230Vac
110W continuous with 200 lfm airflow, 80W
convection cooled – See chart for specific
voltage model ratings.
500µS typ. for return to within 0.5% of
nominal, 50% load step.
i/t
<0.2A/μS.
Max Volt Deviation = 3%
See models chart
See models chart for trip range.
Output Power
Transient
Response
Ripple and Noise
PFC: 75kHz typical
Input-Output: 4000Vac
Input-Ground: 1800Vac
Output-Ground: 500Vac
-10°C to +70°C
Output Voltage
Voltage
Adjustability
Minimum Load
See models chart
Derate output power linearly above 50°C to 50%
at 70°C
+/-10% from nominal on 5V output
-40°C to +85°C
Not required
Operating: -500 to 10,000 ft.
Non-operating: -500 to 40,000 ft.
Total Regulation
See models chart
Operating: 0.003g²/Hz, 1.5grms overall, 3
axes, 10 min/axis
Non-Operating: 0.026g²/Hz, 5.0grms overall,
3 axes, 1 hr/axis
W: 2.0” x L: 4.0” x H: 1.3”
Relative Humidity
5% to 95%, non-condensing
Operating: Half-sine, 20gpk, 10ms, 3 axes, 6
shocks total
Non-Operating: Half-sine, 40 gpk, 10 ms, 3
axes, 6 shocks total
EN/CSA/UL/IEC 60950-1, 2
nd
Edition
Vibration
Shock
Dimensions
Safety Standards
Weight
200g
MTBF
245,000 hours, 25°C Ambient, 110Vac input
Auxiliary Signals
AC Power Fail:
During normal operation, stays HIGH. Signal
goes LOW with at least 6mS warning before
loss of DC output from AC failure.
(5V output, optional) Will compensate for 0.5V
drop min. Will operate without remote sense
connected. Reverse connection protected.
DC OK:
Open collector logic signal goes and stays HIGH
100mS to 500mS after main output reaches
regulation.
Remote Sense:
Notes:
1. Specifications are for convection rating at factory settings at 115 Vac input, 25°C ambient unless otherwise stated.
2. For DC input an external DC safety rated fuse must be used.
www.slpower.com
CINT3110 REV 1.1, 26-NOV-12
2