SL74HC123
Dual Retriggerable Monostable Multivibrator
The SL74HC123 is identical in pinout to the LS/ALS123. The device
inputs are compatible with standard CMOS outputs; with pullup
resistors, they are compatible with LS/ALSTTL outputs.
There are two trigger inputs, A INPUT (negative edge) and
B INPUT (positive edge). These inputs are valid for rising/falling
signals.
The device may also be triggered by using the CLR input (positive-
edge) because of the Schmitt-trigger input; after triggering the output
maintains the MONOSTABLE state for the time period determined by
the external resistor R
X
and capacitor C
X
. Taking CLR low breaks this
MONOSTABLE STATE. If the next trigger pulse occurs during the
MONOSTABLE period it makes the MONOSTABLE period longer.
•
Outputs Directly Interface to CMOS, NMOS, and TTL
•
Operating Voltage Range: 3.0 to 6.0 V
•
Low Input Current: 1.0
µA
•
High Noise Immunity Characteristic of CMOS Devices
ORDERING INFORMATION
SL74HC123N Plastic
SL74HC123D SOIC
T
A
= -55° to 125° C for all packages
PIN ASSIGNMENT
LOGIC DIAGRAM
FUNCTION TABLE
PIN 16 =V
CC
PIN 8 = GND
Note
(1) C
X
, R
X
, D
X
are external components.
(2) D
X
is a clamping diode.
The external capacitor is charged to V in the stand-by
CC
state, i.e. no trigger. When the supply voltage is turned off
C
X
is discharged mainly through an internal parasitic diode. If
C
X
is sufficiently large and V
CC
decreases rapidy, there will be
some possibility of damaging the I.C. with a surge current or
latch-up. If the voltage supply filter capacitor is large enough
and V
CC
decrease slowly, the surge current is automatically
limited and damage the I.C. is avoided. The maximum forward
current of the parasitic diode is approximately 20 mA.
A
Inputs
B
H
X
H
L
L
X
H
X
L
L
H
L
X
CLR
H
H
H
H
L
*
L
*
H
*
H
*
Outputs
Q
Q
Output
Enable
Inhibit
Inhibit
Output
Enable
Output
Enable
Inhibit
Note
X = don’t care
*
- except for monostable period
SLS
System Logic
Semiconductor