USB2224-NE-02 参数 Datasheet PDF下载

Bus Powered USB2.0 Flash Media Controller

Datasheet

Chapter 6

Pin Descriptions

This section provides a detailed description of each signal. The signals are arranged in functional groups

according to their associated interface.

The “n” symbol in the signal name indicates that the active, or asserted state occurs when the signal is at a

low voltage level. When “n” is not present before the signal name, the signal is asserted when at the high

voltage level.

The terms assertion and negation are used exclusively. This is done to avoid confusion when working with

a mixture of “active low” and “active high” signal. The term assert, or assertion indicates that a signal is

active, independent of whether that level is represented by a high or low voltage. The term negate, or

negation indicates that a signal is inactive.

6.1

Pin Descriptions

Table 6.1 - Pin Description

NAME

CF Chip Select

1

CF Chip Select

0

CF Register

Address 2

CF Register

Address 1

CF Register

Address 0

CF Interrupt

CF Data 15-8

BUFFER

DESCRIPTION

TYPE

CompactFlash (In True IDE mode) INTERFACE

CF_nCS1

O8

This pin is the active low chip select 1 signal for the CF

ATA device

CF_nCS0

O8

This pin is the active low chip select 0 signal for the task

file registers of CF ATA device in the True IDE mode.

CF_SA2

O8

This pin is the register select address bit 2 for the CF

device.

CF_SA1

O8

This pin is the register select address bit 1 for the CF

device.

CF_SA0

O8

This pin is the register select address bit 0 for the CF

device.

CF_IRQ

IPD

This is the active high interrupt request signal from the CF

device.

CF_D[15:8]

I/O8

The bi-directional data signals CF_D15-CF_D8 in True

IDE mode data transfer. The bi-directional data signal has

an internal weak pull-down resistor.

CF_D[7:0]

I/O8

The bi-directional data signals CF_D7-CF_D0 in the True

IDE mode data transfer.

SYMBOL

In the True IDE Mode, all of task file register operation

occur on the CF_D[7:0], while the data transfer is on

CF_D[15:0].

The bi-directional data signal has an internal weak pull-

down resistor.

This pin is active high input signal from CF card.

This card detection pin is connected to the ground on the

CF device, when the CF device is inserted.

This card detection pin is connected to ground on the CF

device, when the CF device is inserted.

CF Data7-0

IO Ready

CF Card

Detection2

CF Card

Detection1

CF_IORDY

CF_nCD2

CF_nCD1

IPU

IPU

IPU

Revision 1.3 (09-21-04)

Page 10

SMSC USB2224

DATASHEET