欢迎访问ic37.com |
会员登录 免费注册
发布采购

TDA7388 参数 Datasheet PDF下载

TDA7388图片预览
型号: TDA7388
PDF下载: 下载PDF文件 查看货源
内容描述: 4× 41W QUAD桥汽车广播功放 [4 X 41W QUAD BRIDGE CAR RADIO AMPLIFIER]
分类和应用: 放大器
文件页数/大小: 10 页 / 214 K
品牌: STMICROELECTRONICS [ STMICROELECTRONICS ]
 浏览型号TDA7388的Datasheet PDF文件第2页浏览型号TDA7388的Datasheet PDF文件第3页浏览型号TDA7388的Datasheet PDF文件第4页浏览型号TDA7388的Datasheet PDF文件第5页浏览型号TDA7388的Datasheet PDF文件第6页浏览型号TDA7388的Datasheet PDF文件第8页浏览型号TDA7388的Datasheet PDF文件第9页浏览型号TDA7388的Datasheet PDF文件第10页  
TDA7388
Figure 13. Output Noise vs. Source
Resistance.
Figure 14. Power Dissipation & Efficiency vs.
Output Power.
5
APPLICATION HINTS
(ref. to the circuit of fig. 4)
5.1 SVR
Besides its contribution to the ripple rejection, the SVR capacitor governs the turn ON/OFF time sequence
and, consequently, plays an essential role in the pop optimization during ON/OFF transients. To conve-
niently serve both needs,
ITS MINIMUM RECOMMENDED VALUE IS 10µF.
5.2 INPUT STAGE
The TDA7388’S inputs are ground-compatible and can stand very high input signals (± 8Vpk) without any
performances degradation. If the standard value for the input capacitors (0.1µF) is adopted, the low fre-
quency cut-off will amount to 16 Hz.
5.3 STAND-BY AND MUTING
STAND-BY and MUTING facilities are both CMOS-COMPATIBLE. If unused, a straight connection to Vs
of their respective pins would be admissible.
Conventional/low-power transistors can be employed to drive muting and stand-by pins in absence of true
CMOS ports or microprocessors. R-C cells have always to be used in order to smooth down the transitions
for preventing any audible transient noises.
Since a DC current of about 10
µA
normally flows out of pin 22, the maximum allowable muting-series re-
sistance (R2) is 70KΩ, which is sufficiently high to permit a muting capacitor reasonably small (about 1µF).
If R
2
is higher than recommended, the involved risk will be that the voltage at pin 22 may rise to above the
1.5 V threshold voltage and the device will consequently fail to turn OFF when the mute line is brought
down. About the stand-by, the time constant to be assigned in order to obtain a virtually pop-free transition
has to be slower than 2.5V/ms.
7/10
深圳市品良电子有限公司   联系电话:0755-21236250   �½��½��½�.�½��½��½�-�½��½��½�.�½��½��½�.�½��½�